cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
477
Views
0
Helpful
2
Replies
Tech Support
Beginner

Router OSPF enable is not showing // ASR9901

Hello 

A new ASR 9901 and trying to activate ospf under global or interface mode, the ospf commands are not showing !!

 

RP/0/RSP0/CPU0:AGG-01(config)#router ?
bgp BGP configuration subcommands
hsrp HSRP configuration subcommands
lisp LISP configuration subcommands
rib RIB configuration subcommands
rip RIP configuration subcommands
rpl IPv6 Routing Protocol for Low-Power and Lossy Networks (RPL)
static Static route configuration subcommands
vrrp VRRP configuration subcommands

 

RP/0/RSP0/CPU0:AGG-01#show license usage
Sun May 17 10:45:02.167 UTC

License Authorization:
Status: No Licenses in Use

RP/0/RSP0/CPU0:AGG-01(config-ospf-area)#?
#-remark Remark beginning with '#'
<0-4294967295> 32-bit decimal number
A.B.C.D Specify an IPv4 address / Specify an IPv4 ACL
abort Discard RPL definition and return to top level config
end-set End of set definition
exit Exit from this submode
show Show partial RPL configuration
RP/0/RSP0/CPU0:AGG-01(config-ospf-area)#

 

 

Is there any license or L3 package need to be active ?

2 REPLIES 2
smilstea
Cisco Employee

Do you have the ospf package installed? (show install active summary)

 

After installing the base iso you also need to install the optional packages.

 

Sam

Solved , show install inactive showing the OSPF , MPLS , MPLS TE packages not active.

Thanks for advice