snmp-server enable traps snmp authentication linkdown linkup coldstart warmstart on IOS XR?

[ปลาวาฬทราย RMUTT CPE IX]

I would like to know what is the IOS XR command? for:

snmp-server enable traps snmp authentication linkdown linkup coldstart warmstart
snmp-server enable traps envmon fan shutdown supply temperature status

Thank you very much.

[ปลาวาฬทราย RMUTT CPE IX]

Is this correct?

Command in IOS	XR command	Remark
snmp-server community abc RO	snmp-server community abc RO
snmp-server trap-source Loopback0	snmp-server trap-source Loopback0
snmp-server source-interface informs Loopback0	-	Using snmp inform on IOS-XR snmp-server host 11.10.100.121 informs version 2c abc
snmp-server enable traps snmp authentication linkdown linkup coldstart warmstart	snmp-server traps snmp snmp-server traps snmp linkup snmp-server traps snmp linkdown snmp-server traps snmp coldstart snmp-server traps snmp warmstart snmp-server traps snmp authentication
snmp-server enable traps envmon fan shutdown supply temperature status	snmp-server traps fru-ctrl
snmp-server host 11.10.100.121 version 2c abc	snmp-server host 11.10.100.121 traps version 2c abc

[Aleksandar Vidakovic]

most of it is correct. To understand what kind of notification is triggered with the "fru-ctrl" trap please refer to Table 3-2 of:

http://www.cisco.com/c/en/us/td/docs/routers/asr9000/mib/guide/asr9kmib/asr9kmib3.html

I suppose you want to use "snmp-server traps sensor" along with "fru-ctrl". The "snmp-server traps sensor" triggers the entSensorThresholdNotification.

Regards,

Aleksandar

[ปลาวาฬทราย RMUTT CPE IX]

I can’t configure these commands on CRS-1 XR version 3.6.3. How should I do?

snmp-server traps snmp linkup
snmp-server traps snmp linkdown
snmp-server traps snmp coldstart
snmp-server traps snmp warmstart

Thank you very much.

[osman]

For the CRS platform, support for these options was added into Release 3.9.