Hi
Currently I have 4 slots occupied by the following cards on ASR9000:
Slot 0 – A9K-8T-L
Slot 1 – A9K-8T-L
Slot 2 - A9K-2T20GE-L
Slot 3 – A9K-2T20GE-L
have VRFs configured on different ports within each card, the installation process was carried license type A9K-AIP-LIC-B but only on slots whit line card A9K-2T20GE-L is possible to observe that license are that used. e.g.
RP/0/RSP0/CPU0:ED_MEX_2#sho license (ASR 2)
Mon Dec 2 12:30:55.123 pst
FeatureID: A9K-AIP-LIC-B (Slot based, Permanent)
Total licenses 4
Available for use 2
Allocated to location 0
Active 2
Store name Permanent
Store index 1
Pool: Owner
Total licenses in pool: 4
Status: Available 2 Operational: 2
Locations with licenses: (Active/Allocated) [SDR]
0/2/CPU0 (1/0) [Owner]
0/3/CPU0 (1/0) [Owner]
if I try to make the assignment of the license to a slot that does not have no notice that the license is assigned, the follow procedure we used to assigne the license to slot.
RP/0/RSP0/CPU0:ED_MEX_2(admin-config)# license A9K-AIP-LIC-B
location 0/0/CPU0
but the show license is the same
FeatureID: A9K-AIP-LIC-B (Slot based, Permanent)
Total licenses 4
Available for use 2
Allocated to location 0
Active 2
Store name Permanent
Store index 1
Pool: Owner
Total licenses in pool: 4
Status: Available 2 Operational: 2
Locations with licenses: (Active/Allocated) [SDR]
0/2/CPU0 (1/0) [Owner]
0/3/CPU0 (1/0) [Owner]
only have the owner on slots 2 and 3.
This is a possible error on IOS that need it to upgrade with SMU or licenses can only be used with slots containing VRFs contained above the base license?
Best Regards
