When using an XR router as a dhcp relay agent (or proxy if you want), is there a way to specify the default router field in the DHCP server response? According to my customer they are doing this with another brand router in which the dhcp server sends the response and omits the default-router information and the router inserts this information in the response.
Can this be done on a Cisco XR router? If yes, how?
CCO documentation lists out the ability to do a password recovery for eXR with a ZTP/PXE boot.
One can also perform the operation manually, like a "turboboot" for classic XR in this facinity.
this procedure will wipe out the complete system and install a...
Below is a link to a video showing how to analyze traceroute output in L3VPN and look up CEF forwarding and MPLS/TE/SR/SR-TE forwarding for labels through a domain. Some basic examples of traffic engineering are used but the concepts lend the...
This document summarises various health checks that can be done on a Cisco VIM pod.
Cloud sanity checks the health status of network, storage and various openstack infrastructure components like mariadb, rabbitmq etc....
The following pre-requisites are necessary for the migration from RSP440 to RSP880-LT to be successful.
Make sure that you have console access to the router.
Verify that the system is running a minimum o...
BGP flowspec in a nutshell is a feature that will allow you to receive IPv4/IPv6 traffic flow specification (source X, destination Y, protocol UDP, source port A .. etc) and actions that need to be taken on that traffic (...