Other Network Architecture Subjects

Okay, simple question:I have slot0 with two images, disk0 with one image, both flashes in the same router, a 7204-VXR. If the boot system command is not specified pointing to a particular image, which image will be used to start the router? What is t...

I have two cisco catalyst 9300 switches with a trunk between the two. The monitoring session destination interface gig 1/0/24 is not displaying any output traffic. below are the configurations i have in place:Type : Local SessionSource VLANs :Both : ...

Hi all,I have a need for a static route to be used instead of a directly connected route. (Long story - involving firewalls and anti-spoofing.. but can go further if required)I am using a Cisco 3750 switch. I notice directly connected routes have a ...

I been have a problem the WLC sometimes when try to connect with its ip 192.168.99.5 sometimes it request timeout and sometimes after closing the file opening it back up it works okay. And during the time it works the LAP received the CAPWAP status o...

Hi, does the lab created in version 8.2.1 work the same in the latest version, 8.2.2? I have done multiple labs in version 8.2.1, and I am afraid if I uninstall it and install the latest version, 8.2.2, I cannot open my lab file or my lab will not wo...

I am facing an issue with integrating a new customer, Customer B, into our network. They have developed a virtual system that uses the same IP addresses as another one of our customers, Customer A. Customer B mentioned that it would take a significan...

Hi,is there any command to check the powersupply details on WS-C2950G-24-EI Switch. i tried show env all but it is showing only the status.But my requirment is to find the type of power supply provided to that switch like, Whether AC/DC Powersupply ...

Hey everyone, My company is looking for a senior level telecom engineer who is well-versed in Cisco UCCE (not UCCX) technology. The job is in a very secure company just outside of Philly. It is an onsite opportunity (no exceptions); however, after 90...

I have a CAT4006 with 2 2950 connected via Trunk ports to the Gig uplinks g1/1 and g2/1. I had previously set up vlans with no problem. However when I set one up today one of the 2950's shows the status as act/lshut. Any ideas?

We have a ring of switches in the network, and from each ring node (DIST) downstream, there are one or more access switches (ACC).  Each sw_DIST has the following configuration: interface vlan300ip vrf forwarding NET2ip address 172.16.X.1 255.255.255...

 https://www.cisco.com/c/en/us/td/docs/security/secure-firewall/management-center/device-config/720/management-center-device-config-72/interfaces-settings-ifcs-firewall.html#Cisco_Generic_Topic.dita_1778151e-e768-4581-a67d-be555f8ca57cTrying to follo...