ACE 4710 farm selection based on source IP

[davidfarjecalderon]

Hello Everyone,

I have a requirement to select a farm based on source IP address.  I tried creating a match all class-map that matches on the virtual-address and source address but I get this message.

LB01/Admin(config-cmap)# match source-address x.x.x.75 255.255.255.255

Error: Only one match virtual-address is allowed in a match-all class-map and it cannot mix with any other match type

To me this is the only place where it makes sense to set the source match criteria.

I would apprecitate documentation or insight on how I can do this.

Best Regards

[pablo.nxh · Accepted solution]

Hi David,

This post may help you to get this working: (You don't want to add the match source-address command within the same

class-map that is matching the VIP)

https://supportforums.cisco.com/message/3389845#3389845

HTH

__ __

Pablo

[Jorge Bejarano]

Hello, David

That error which you are getting is totally expected since you are using an equivalent matching method in both cases, then the ACE won´t know which to select one.

Perhaps, what you can do is to use a second class-map which will be match under the policy-map of the original class-map

I wonder why you would like to match both, the vip and the source address?

Jorge