Application Networking

I have a client that I recently replaced their GSS's for and last evening I cut them over to an HA pair of ACE 4700's.  After about an hour, it looks like the GSS and ACE stopped communicating with each other.  When this happened, they switched back ...

Is someone able to let me know which is the correct license below for a Nexus switch bundle N5K-C5596UPM-B-S96? I get different results from CCW and the Dynamic configurator tool (please kill off one or the other - different results from two tools is...

We currently have ACE20's, which only support multicast in bridge mode.Was wondering if it's the same on ACE30's, or if Cisco finally implemented support for mcast in routed mode.thxKevin

Hello All,I am performing my first ACE deployment in bridged mode by creating rules for adding a new VIP, rservers, serverfarms  for http & https traffic utilizing http to https redirection configuration as well.Since I am new to ACE deployments, I w...

We currently have a 6500 chassis with CSM, I need to start migrating services on this over to an ACE30. Both modules are currently in the chassis, has any one ever had any issues running both modules at the same time ?The ACE will be using completely...

I created expired certs.  Did my setup.  Everything is working, but found that I had created the certs with expired CERTS.I recreated the certs for a future date.  I do a sh crypto cert all.  They show the proper day.  Tested it with a broswer and it...

Hi everyone.I've just run the ACE 4710 and it seems that is booting up well but it stops when 'Setting up dynamic memory size' message appears.INIT: version 2.85 bootingb4 lspci1 Cavium device(s) found.Bringing up NP 0Downloading U-Boot to NP card 0D...

here is configwe are trying to load balance non standard portsrservers and vserver all show as upbut vip can not be pinged and no connections flowlogging enablelogging timestamplogging buffered 3resource-class RC1  limit-resource all minimum 0.00 max...

Hello,I have installed ANM 5.2 virtual appliance.I have an issue importing a Catalyst 6500 device.When I try to import it, I get the following error:Device discovery failed: Cannot communicate to the device.Authentication failure while attempting to ...

Hello all,I've got an issue with a CSS 11501 where, if *any* change is made to a global keepalive (active), the device reboots. The code is 08.10.2.05. Is this a known issue with this code revision that has been resolved with a later code? I'm unable...

Hi, I am new to ACE module config. I need help to configure url redirection from https to http for my MAPI servermean client will connect through https://webmail.test.com then it will redirect to http://webmail.test.com/owa to get the web page.now wi...

HI all , 1 )  I  Received a requirement as to perform the https to https redirection and do the ssl   installation in   CSS load balancer . Redirection need to happen from https://www.abc.com to https://www.abc.com/fcbd . i have a confusion in , how ...

I have a need to use the one armed load balance for some servers. I have 4 contens setup using this and I have the four corresponding Groups setup. Two of the contents work fine they are using SSL. The other 2 fail and they are both using FTP. It loo...

Hello Everyone,I have a problem here.I trying configure ASN traffic loadbalance, but doesn't works.Explanation: I have one Cisco Catalyst 6509 and onde Cisco Ace10 module, in my context "PanWEB" i have the interfaces above:interface vlan 4(rservers i...