Application Networking

        Hello,I need to configure a keepalive that check an url in a server   (http in port 9500 not in port 80) and check the port 443 in the same server. If any of them not response . the service should go down.Anyone can helpme.thanks in advance  ...

I want to setup my core switch to receive the LAN and WAN (interface inline) of WAAS. I believe the I need to create a different VLAN for each interface, but after what Do I need to do and  which are issues that I need to be worry myself?Virtual Inli...

We created a capture on an ACE30 module A5(1.2). Used the capture a couple of times. Copied cap files to disk0, then offloaded. It appears that the capture buffer may still be alive, but we cannot open the capture, remove the capture or display the c...

Any idea or configuration example on how to reconstruct the original client IP address from X-forwarded-for in HTTP request?

Hi AllI am seeing the following error: %ACE-LB_GENERAL-2-728033: Failed to establish Web Application Acceleration connection: Maximum concurrent connections limit (52) reachedI am checking the doc's and can see this is a licensed feature, the questio...

We have 2 ACEs configured as Active/Standby.  FT vlan is configured directly using a crossover cable , not using a switch for the FT vlanACE is setup in routed mode ,vlan 29 is client vlan and 28 is server vlan ,both are being trunked on ACE-- trunk ...

Normal structure:Mounted file systems:MOUNT POINT      TYPE       DEVICE                SIZE     INUSE      FREE USE%/sw                        internal   /dev/sda1            991MB     677MB     314MB  68%/swstore                 internal   /dev/sda...

Hello ACE experts, I have two questions;Design;One-armed ACE appliance where the servers use the ACE as default gateway? (and ACE of course a default route to the router) Apparently it works in my lab… But since it’s not documented I wonder what the ...

Hi,I had configured ACE for loadbalanc IPSEC traffic to my VPN Router. For IPSEC to work configured with leastconns with ip base stickyness  and running software version A2(3.4). I am facing following issue :My configuration is working fine in normal...

Probe Interval: 5Pass Detect (Seconds): 60 Fail Detect: 3Please can someone explain the above settings that are configured for a health probe?  am I correct in thinking the probe is sent every 5 seconds, and must fail 3 times in order to failover?  D...

Hi,Any date for the 4.5.1 ?We need the Citrix AO for an new project.Regards Jan Rockstedt