Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I am trying to add an Email security appliance to SMA but I have a timeout error.I can ssh to both ESA and SMA but when I telnet using CLI (from ESA to SMA and from SMA to ESA) I do not get the prompt to insert username and I get the following ...
Hello,I have to configure two 4221 (Version 16.9.3) with HSRP and NAT. I have one inside interface and two outside interfaces. I have configured NAT (static source) using route-maps stating which traffic should be met to NAT to different IP addresses...
Hello,
I am trying to setup CMX engage (cloud) with my WLC.
I follow these steps:
To import the DigiCert CA root certificate to connect the WLC successfully to CMX Engage. perform the following steps:
Step 1 Download your root certificate from the f...
Hello,
I have done some reading on how to convert a Cisco 1850, my understanding is:
- if I have a ME AP image then I can convert him to CAPWAP by just typing ap#ap-type capwap
- if I have a CAPWAP AP image then I have to download a new image
If I ha...
Hello,
First of all, I want to say that I have very little knowledge of VoIP and collaboration technologies... sorry if question is dumb.
I have a costumer who bought a BE4000 and he is asking me how can he connect fax machine to BE4000. From my dat...
More specificallyI configured ip nat outside source static tcp 10.10.6.50 3389 10.250.36.245 3389 redundancy Inside extendable 10.10.6.50 is real IP address behind g0/0 (ip nat outside configured)If someone tries to RDP to 10.250.36.245 coming from g...
Hello,
You achieved this by using regular uplink ports from switch? Or are you using the new FlexStack-Extended modules (fiber or hybrid)?
From what I have read, it seems that we can use regular uplink ports for stacking (without the need to buy an s...
