Application Networking

Hi ,I upgarded the WAAS os from 4.2.3 to 4.3.3 on a WAE-274 . The "sh ver" ," sh flash" result shows the WAAS OS as 4.3.3. But in WAAS CM, under s/w version the device shows "4.3.3 {update failed} " error .I also tried to reload the device after upgr...

how i get my contract support coverage

Experts please let me know ,as we have an application ,where the traffic is not loadbalanced equally on the servers.production# sh serverfarm epmcubesrr serverfarm     : epmcubesrr, type: HOST total rservers : 2 ---------------------------------    ...

We have a mix of ACE20s and ACE30s currently and I am seeing the ACE in both HW platforms failing out our servers sporadically after a sucessful TCP handshake.  Here is the configuration:probe tcp TCP-25   port 25   interval 25   faildetect 2   passd...

6509__________                          -6509____________ ACE1(Primary)    |<-ft trunk->         |ACE2(Backup)        |Switch1(Primary)|<-10 Gig Trunk->   |Switch2(Secondary) |______________                            __________________We power off P...

When I initially configured networking for my ACE XML gateway I set the eth2 interface to AUTO.  Now I want to go back and change it to 100 FULL but when I go back through the Network Configuration menu it no longer presents me with the screen that a...

Hi,  Reading the documentation I believe this is hot swappable although I just replaced disk03 and my appliance stalled,. I had to reboot and remove new drive.  Device has layer 3 up but no ssh or cms connectivity.  Has anyone else seen this I am run...

Got 2 x 2921 SRE WAAS, one at DR center, one at main office. I read from Cisco manual. On DR,Wan Interface configured ip wccp 61LAN interface configured ip wccp 62On Main office'WAN interface configured ip wccp 62LAN interface configured ip wccp 61Is...

I have two vlan interfaces in the same context C2.interface vlan A  description VIP_App  ip address 10.2.1.253 255.255.255.0  alias 10.2.1.4 255.255.255.0  peer ip address 10.2.1.254 255.255.255.0  access-group input Out_Acc_PB  service-policy input ...

Hello,we have a CSM that fails to bring up with the typical Module SCP dnld. Accessing by console we obtain:Laminar v1.0 Starting SDRAM Data bus test...  COMPLETE! Starting SDRAM Address bus test... COMPLETE! Starting SDRAM Fill test ... SDRAM Comple...

Hi All,Can anyone tell me what this syslog message relates to?  I'm seeing it on a whole lot of WAEs.  Is it something I need to worry about or not?nscd: %WAAS-UNKNOWN-5-899999: 5317: Handled cache clean up for SIGHUPThanksClaire

All,I have a number of web sites that are currently being load balanced by CSS 11503s runninng 8x code.  I was recently requested to configure HTTP -->  HTTPS redirects on the CSS for every site.  In the past, I have only configured the redirects for...

Hi ,  Is it possible to load balance real server across the VLANs, I have requirement to load balance two servers which are in two different subnets. Can anyone confirm that it is possible and there are no known issues in that? Here is the script for...