Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
With an ACE SM in the cat65k configured in routed mode and the real servers' defaul gateway being the server side Layer 3 VLAN int on the ACE, when the real server initiates the connection, does it go to the MSFC-ACE-server side Layer 3 VLAN int or d...
I want to configure SSL termination on cisco LB. i just want to know is there any license required for this deployment ? please share me some configuration steps to deploy the SSL.ThanksIrfan Hussain
Hello EveryoneI'm seeing the following on EPM connections and was wondering if this is normal. Version 4.2.1.D:DRE,L:LZ,T:TCP Optimization RR:Total Reduction RatioA:AOIM,C:CIFS,E:EPM,G:GENERIC,H:HTTP,M:MAPI,N:NFS,S:SSL,V:VIDEOConnID Source IP:...
ACE module had bit flip and it was hunged after that.I was not able to run any command(i.e For ex if i run show ft status nothing was displayed).I was not able to run any command on the standby ACE as well is this could be both the ACE module ACTIVE?...
I have a WAE-674 connected to two 6509 switches (sup720). The two WAE ports are in a standby group. I'm also using WCCP L2 redirection from 6509 to the WAE, but I remember in older WAAS software, WAE standby group was not compatible with L2 redirecti...
I have a 3800 ISR with Gig0/0 connected to LAN, Serial0/0 connected to WAN, and Gig1/0 connected directly to a WAE-674. I'm using WCCP between the ISR and WAE. The ISR also does IP inspection and call manager express functions.The "ip inspect in" is ...
Hello Experts,I have a couple of ACE that load balances two web servers using stickyness with cookie insert (BTW the topology is one armed mode). You can see the sanitized config below:rserver host WEBSERVER1 ip address 10.10.10.101 inservicerserve...
Hi all,i have some queries regarding the "show conn" command in Cisco ACE.Working Scenario:VIP : 10.10.10.1Server 1 : 10.10.20.1Server 2 : 10.10.20.2Client: 30.30.30.1When a client 30.30.30.1 initiates a connection to the VIP on 10.10.10.1, the ACE l...
Hi All, I was looking at some of http logs and found the ACNS is initiating a connect to the internet, but it looks like ACNS acts like a proxy, which means some other host behind this ACNS is intitiating the connection, can somebody help m...
Hi GuysHow does domain name content rule works in one arm config.What do we put in source groups as VIP address.Does it need host headers in WebServer as a requirement.How does the client request gets completed.Any help much appriciated..
Hi,We have problem between sites with CIFS.Are running two 674 with version 4.2.1 with inlinecard and 4.2.3 on the CMA.No errors on the interface and fully optimized TCDL.The problem is when we run CIFS remotly to file server the folders are temporal...
Hi - I wanted to know the use of the alias command on the CSM.From what i can make out is thet it is used to assign additional IP Addresses to the CSM Sever VLAN.This IP Address can be used by the Real Servers as the default gateway.Now my question i...
