Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Alright, so I have toiled long and hard to get this right. I think I have the config down but I am unsure on how to verify how this load balancing is working.Here is the Content Config that I am speaking of: content cad-rule add service wls1-e0 ...
Appologies all for another "low end" question,We have an ACE appliance that is in the frame for casuign performance problems. sh resource usage for the context [there is only one + Admin] show a LARGE [almost 0.75Gb]amount of denies in the bandwidth ...
Hi All .. more questions ?We have a web app that requires sticky sessions. We have to use IP as the marker.The IP source has comes from a one-2-one NAT range that has a /16 mask.The sticky config is currently:sticky ip-netmask 255.255.255.255 address...
Hi,I have just performed a capture using a NAM in my 6500 on the port attached to my ACE appliance.What i have noticed in the capture is a lot of duplicate ack errors and tcp out-of-sync errors.The reason we found this was becuase the link utilisatio...
Hello Everyone,Quick background:My background is more in L1-L4, and recently I have been assigned to the ACE project to provide SLB (I know what were they thinking )I am now having to really understand the handshaking mechanism the various protocols ...
Hello,I have a fairly typical load balance configuration on a pair of ACE appliances running (A3)2.5 and now I need to load balance multiple URIs to these same servers on port 80 to the one VIP. Can someone direct me to a doc that shows a good exampl...
I can ping the WAE, WAE can ping CM. But I cannot enable CMS. I am trying to replace the hardware...deactivated old one and changed the recovery password. Plugged new one,raded code to 4.1.3 same as old one and configured basic setup. After that I a...
Does anyone have a clear example of a full configuration including the "portmap vip-address-range" Command? I've done plenty of searches and the best I can come up with is a description along with the CLI command. No where can I find a full configr...
Hi,I am wondering what the status of the query vlan interface means in the command 'show ft peer detail':Query Vlan IF State : UP, Manual validation - please ping peerI am pretty sure that I did not see this status when I configured query vl...
Hello,I have the folowing question: if i have 2 servers, one master and one backup, after a fail in master server ace starts to send connections for backup server. When master server back to online status, ace will send connections to master server o...
HiI have an ACE module that has last boot reason: NP 1 Failed : NP Control Store Parity Error.Does any one know if this is a software issue and I may need to upgarde this software I am running A2(1.5).Regards MJ
Hi,I have configured ACL on CSS 11506 with software version 07.50.1_03.0 .After configuring we observed in show keepalive-summary all Server serivce are up except the App server service where keepalive type TCP & Port is configured we tried by removi...
I have a SSL load balance VIP/Class map which works fine. The problem is that I have a developers of the web apps want to have a link in xml(tom cat app) to a map app(different port same box). It is is behind multiple firewalls and can't get permis...
Hello,Can someone tell me what the default load balance method used in the Cisco CSS 11503? Is it source-based or destination-based?Thanks,Adil Nasseradil.nasser@owenscorning.com
Hello groups,I wanted to know your experiences of using ACE for proxy server load balancing.I want to load balance to a pool of proxy servers. Note: load-balancing should be based on the HTTP URL (i can't use source or dest. ip address) so thata cert...
