Application Networking

TCP/80 keepalive works fine. With default HTTP keepalive the server showed down, so Ethereal traced and discovered response was 302 not 200. Set response code to 302, but still showed down. Any ideas?service Doyle protocol tcp ip address 10.0.126.139...

Hi all,I have a WAAS network with redundant routers and am running WCCP for traffic interception and HSRP between the two routers and each router connects to a separate WAN provider and I have dual WAN connections at most locations except for two (Ch...

Hello -I was wondering if there are any performance issues with using a 4-port HCWIC ethernet module on a WAN router for connecting the WAAS device rather than trunking down to your switch? We have this deployed today in all of our remote sites using...

Hi,I have tried ot enable SNMP on a GSS 4492R-K9 running 3.1(0) software and while the status say's it's enabled it doesn't seem to be working. Viewing the Services it seems it hasn't actually started as a service: START  SERVICE 14:35  Ntp   ?    Sn...

I'm having an issue with direct server access in a one-armed, routed mode as shown below. Packets come in from the router, to the server directly.  When the server responds, the packets go to the ACE as its default gateway, and then are forwarded by ...

We've been having some issues with dropped connections to our VIPs for our 3 contexts (dev, qa, prod).  If I do a show resource usage on those contexts there are many denied packets for bandwidth. Here are the resource allocations for the 1gb license...

Hi all,i've got a pretty strange problem with load balancing with some l4payload criteria. i'll show you configuration (DNS stuff):class-map type generic match-any dns_regex  5 match layer4-payload offset 20 regex ".*corp100.100.*"class-map type gene...

I installed a Squid based caching appliance, by Stratacache. it supports GRE wccp redirect in transparent mode, I have it configured as wccpv2 using the Router's LAN ip address 10.250.1.2.Every time I turn on the caching for a host (or the entire LAN...

Hi All,Need help on ACE,Our customer have ACE Module running in context mode in C6500, customer complains that users are facing slowness accessing application behind the ACE.From his observation he finds that there is huge difference between ACE sess...

We have been using the commit_redundancy script for some time between two CSS 11506's (Ver. 7.50). For some unknown reason after the script is run and it runs the byte count between the two, it fails. When I check the two configurations, the only dif...

Team, I need to install two ANM servers in HA mode. The primary ANM server will be in my primary data-center and my back up ANM server will be located in my back up data-center. Is this possible? Based on what I read in the installation and user manu...

Hiwe have a plateform ACE on our network to loadbalance a website.we have a problem with one website (website shopping).there are a user who have their connection are reset by ACE or Rserver (i don't know).We use a insert cookie (Sticky).we see a tim...