Application Networking

Does anyone have a link to documentation regarding creating custom reports on the WAAS appliance? I have been told that you can create a custom report that will let me look at data for a specific port on a specific day during a specific time. What I ...

Is it possible to cluster WAAS systems? I have heard that is it but I am having trouble locating any documentation on how to do it. Any assistance would be appreciated.

I have a question about the information displayed on the Traffic Summary Report.Can any one explain to me how the Optimized Traffic value can be major than the Original Traffic value???Thank you for assistance,Diego

Hi friends, sorry if this is a silly question, I have a C2811 with a NM-WAE-502. How can I check is the license is an Enterprise or transport? If I have a transport license, How can I upgrade to Enterprise License? Thanks for the info guysDavid

I created and prepositioned approximately a 725Mb share. The preposition status reports that the directive took 15 minutes to complete. We then connected to a PC at the remote location and mapped to the share here at corporate. We then copied the fil...

Hello -I'm looking for the Cisco recommended WAAS software version to run? I need this for auditing purposes.

Hi guys,My costumer is using the waas solution and its working fine, but few days ago my costumer bougth some new waas hardware.Almost of all prodution waas is running 4.1.1c version and the new waas is running 4.1.3b.I would like to know if the solu...

Hi,Can someone tell me how to configure a new context on an ACE Module that is inserted into a 6500 switch. Please also tell me about the configurations of ft vlans for the contexts.I read some documents and can grasp the crust of it.. Thanks

Hi,Is it normal to see traffic on the secondary server in a serverfarm like the below output. If its secondary it shouldnt be recieving any traffic until the primary goes down or offline. rserver: 192.168.10.40 192.168.10.40:8000 8 OPERATIONAL 3 1181...

Hi there, i am having a problem with a CSS 11501 machine. Problem started with a faulty compact flash slot0 that was replaced with the compact flash in slot1. since i had the configuration backed up i restored it to the new compact flash and also upd...

Hi,While configuring an HTTPS probe I observe that if the certificate on the target server is expired, the ACE marks the server as PROBE-FAILED. A Wireshark trace shows that the ACE refuses an expired certificate. Here is the probe configuration :pro...

Hi all,I have a CSM-config with 16(32 vlan) bridges in one context and want to move them to a ACE-blade. I can't declare more than eight route entrys. Shall I define defaultgateways as real servers and what about mac-sticky enable? RegardsMats

Goodday,I would like to confirm if one can only assign a single user Admin access to a context via RBAC (either on ANM or ACE native RBAC through ACS). So is this true or not?If so, would I be correct in assuming this excludes the default Admin user....

Hi, can anyone please explain how you can monitor the ACE module with XML. I've read the limited Cisco documentation about the XML interface and read posts about using curl but I don't understand how you combine the two to automatically extract the d...