Application Networking

Hi Guys,I'm needing some help to implement WAAS at a Catalyst 4500 in Hardware.I have 2 WAEs 512 at Main Office and 2 NM Modules at Branch Offices. The Branch connect to Main thru VPN. At remote sites I'm using ip WCCP in and out at LAN router interf...

I have configured two acceleration WAEs - one in the DC and one in the branch. In the DC the interception of data traffic is using inline card (I use all four ports) and in the branch the interception of data traffic is using WCCPv2 (NME-WAE-522). Bo...

We have 4 contexts on the ACE and two of them have similar names: XYZW and XYZW-old. Could that have anything to do with the fact that when we do the "change ?" command, the XYZW context is not showing?Thanks..

Can you tell me if this will work? keepalive type encrypt keepalive method get keepalive port xxxxSpecifically, what can I do for a layer 5 KAL for HTTPS in a service? I hate to compare these things but I know on an F5 I can do an https get.These ...

Hello,Anyone know if it is worth upgrading from 4.1.3a to 4.1.3b? I may plan to wait for 4.1.5, anyone know when that will be available?

dear siri two Cisco CSS11501 they work in redundant i finish the configuration but when i try to access the application using the VIP it's fail with the att. is configuration for both CSS any help

Hi, I wanted to learn about ACE appliance. I am not able to find any suitable documentation on cisco site to learn ACE.I want documentation which would give information like what is ACE and how it works. I have documentation how to configure and all....

I need to configure sticky on the base jsessionid in the following URL:GET /forms/lservlet;jsessionid=0ad20c2630d669f096be228c4e28b46bdfab35277e64.e34SahePax0Kby0MahqPbNyPbx50n6jAmljGr5XDqQLvpAe?ifcmd=getinfo&ifhost=PC7&ifip=10.210.200.17 HTTP/1.1\r\...

Hi…I have configured the ACE for Bridge mode and everything is fine except for one thing. That is when anyone enter our portal page and enter the username and password it takes around 20 sec to login. After login everything is fine and fast… Why...

Does the ACE translate the destination address of an inbound packetfrom its own address (the virtual server's) to the backend server' vlan or simply route it to that vlan?

HiI have configured CSM to redirect one of our website to different URL. It works fine for 3 - 4 time and after that it stops working. When I check on our internet facing firewall, noticed that getting an error message saying"First packet isn't syn t...