Application Networking

Goodday,I have an issue when trying to setup ACE Modules for TACACS+ and AAA autentication whereby the Failed Authentication reports, state the reason as "Key Mismath".We have confirmed that the key we are using is the same on the ACE and on the ACS....

I need to find the last user which configure a Cisco CSS. But when I did the command Show log ... it doesn't really shows up Is there another way which I could do this ? I don't think syslog was configured.Thanks again.

The customer will use WAE with inline card between a router and LAN switch. There is a switch module in the router. Tha WAE will be connected into a port on the switch card (HWIC-4ESW) and into a port on the LAN switch. The both ports are FastEtherne...

Has anyone experienced any issues with Unix systems when adding rules to WAAS for port 514? This is the port RCOPY uses and is not handled by WAAS by default. We created a rule for port 514 but when we implement any type of optimization (even TFO Onl...

Hi AllI have a design where all my WAE are inline in the path of traffic .One of my WAE Edge shows on the CM as offline and after half an hour it comes online , again it went offline after 1 hour and so on.What might be the issue and when its offline...

I am deploying a proof of concept with WAAS v.4.1.3a and am having a problem with the remote WAEs.I have the CM running and the host WAE is registered using WCCP. The remote WAE will not register to the CM. They can all ping each other, but when I ty...

I have a site where the LAN switch behind WAN router is a Layer 3 switch, and the link between the switch and router is now a Laye 3 link. Router will do WCCP interception, and WAE will be connected to the LAN switch. Since the swich is Layer 3 switc...

Hi, Could anyone help with this issue, i am trying to get Cisco 3560 to redirect traffic to a WAE appliance.Attached is the show run and debug output of the appliance thanks!!   

I am a new user with the Cisco 4710 appliance and am trying to load balance Microsoft ISA servers with our 4710s. They are currently deployed in routed mode with one acting as a hot standby.My issue is that the traffic doesn't seem to be getting to t...

We have configured our CSS to do basic Roundrobin load balancing between 3 webservers. Occasionally we notice that between 1/3 and 1/2 of the requested page content loads and then the browser gives a page cannoot be loaded response. A refresh then lo...

I'm having an issue with a service on my CSM where the server log is showing "An error occurred receiving data from (10.129.53.250) over TCP/IP. This maybe due to a communications failure". That address is the CSM NAT Address. When I do a packet capt...

Does anyone have procedures to create CSR on cisco ACE module? Thanks

I know stateful connections failover is supported between redundant CSM modules. Is it also supported between 2 RIPs within a sfarm. i.e while an active connection session is being served by real server 1 and for some reason it malfunction, will the ...

I have a branch site where a Layer 3 3750 switch is behind the WAN router. The 3750 has all the VLAN interfaces and runs OSPF with the WAN router. So my question is: when configure WCCP, should I configure it on the 3750 switch or the WAN router?The ...