Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I know stateful connections failover is supported between redundant CSM modules. Is it also supported between 2 RIPs within a sfarm. i.e while an active connection session is being served by real server 1 and for some reason it malfunction, will the ...
I have a branch site where a Layer 3 3750 switch is behind the WAN router. The 3750 has all the VLAN interfaces and runs OSPF with the WAN router. So my question is: when configure WCCP, should I configure it on the 3750 switch or the WAN router?The ...
Hi, I have configured a new ACE 4710 with only a sinlge context to redirect https traffic to http real servers using SSL Termination. When I do a telnet on port 443 or 80 to the VIP it works fine but when I try to open the URL it prompts me for accep...
I am trying to replicate this environment (see attached) on our new ace appliances but it doesn't like what the css-conversion tool had me do and the only way I can make it work is with transparent mode, no NAT, and the default route being set on my ...
Hello,I'm using an ACE4710 as load balancer.I have 3 InterfaceINTERNET 10.47.100.249 255.255.255.0INTRANET 10.47.99.240 255.255.255.0PROXY 10.47.98.240 255.255.255.0Traffic coming from INTRANET is balanced on interface PROXY if is HTTP.Routing table ...
Can someone provide some information on how you would setup 2 servers to proxy out as the VIP address? On the CSS I know you can accomplish this though the use of a group ruleEx: group Outbound_Proxyvip address 192.168.1.xadd service web1 add service...
Is there anyway to pull all of the context configures in one shot? Can I copy them from the Admin context or do I have to changeto each context and do a copy run?Thanks.
hi,can anyone shed some light on how to clear the charts and graphs on the WAE's?i've run "clear stats all" on all devices but am still showing previous dataregs
Hello Everyone,I'm sure I'm not the only one out there when I say this; the central manager's reporting on how much bandwidth you're saving is pretty much useless! Has anyone tried to print out the reports or even saved it to a PDF without the colors...
Dear All,We have upgraded the CSM software from 3.1(4) to 4.2(12).After upgrading the CSM software and reset, CSM module is in unknown state as shown in the following output:Switch#show module 8Mod Ports Card Type Model Serial No.--- ----- ----------...
On a CSM, if there is more than one probe configured on a serverfarm, lets say 3 probes, ping, http and port 4400, if one of these probes fails then is the real server marked as failed, or do all 3 probes have to fail before the server is marked as f...
