Application Networking

Hi Experts, If i try to nslookup directly with GSS ip address. I do get a responce with vip ip address.When i use my local dns server.. where i have an entry to saying my authorative server for domain x.com is GSS.If use the dns server ip address ..i...

Hi, I had a migration this last weekend. I ran into an issue that most of the servers would fail HTTP probes, but when configured for ICMP the servers would answer it's probe and load balancing works fine.What is the major symptom of this issue?Thank...

I try establish an connection client (with WAAS Mobile Client)/server (my application), but when I running WAAS Mobile I see in Wireshark the following: SYN->SYN,ACK->RST. The reset packet has the following:Acknowledgment number: Broken TCP. The ackn...

I need change a couple of disk in Wae 512. My question is, Is neccesary run the recovery waas image disck? or only I need to change the disk's.Thanks

Does anyone have some general feedback on the 4.1.3 software that has been out a little over a month now? When is the next minor release of 4.1.3 expected to be released?Thanks

I'm not familiar with the 6500 modules that loadbalance; ie. ACE, ACN etc. But, I may need to start looking into using a loadbalancer in our dual 6500 distribution layer switches to loadbalance WCCP redirected traffic to our 7341s in our data center....

Hi All, We're currently in the process of setting up a WAAS environment for a customer, comprising WAE-512's at the central site with WAE-502's at remote sites. The lab environment has a single server next to the WAE-512's and the remote site is conn...

If router is configured with WCCP redirection already but WAE is not in the network, does router redirect traffic? How does router detect WAE to start redirection?ThanksGary

If I have a WAE (inline mode) at a branch site where the site has its own Internet connectivity (not going through data center), does the WAE cache HTTP traffic between the site and Internet?Does HTTP caching in WAAS only refer to the HTTP traffic be...

I'm setting up a router and a WAE using WCCP. I know WAAS passes through VoIP bearer and signalling traffic if the traffic is redirected from router. But does router redirect voice traffic to WAE? If it does, that may cause additional delay even thou...

HiThe installation guide for ANM 2.1 says that RedHat AS 5 Update 2 (5.2) 32-bit Server Edition (Linux 2.6 Kernel) must be installed if you are installing ANM for the first time on a server where it has never been installed.Is AS really required as i...

Hello everyone,What is the recommended method for configuring WCCP on the WAAS to register to an ISR router running version 12.4(24)T? I been going back and forth on whether or not to use L2 forward/return w/mask or GRE forward/return w/mask or hash....

Hello,I'm trying to monitor certain SNMP Objects from the CISCO-SLB-MIB but I'm getting a permission "not-accesible" from the NMS. Does anybody know what could be the problem?Many thanks for your support.

Hi everyone, I'm running version 4.1.1d, I'm unable to use the tcpdump/tethereal to perform a pre capture filter on only devices using WCCP GRE, it works fine using WCCP L2. Has anyone ran into this problem?