Application Networking

Hi,Is there a way to configure redirect type NCI-TYPE-INFO only - on the ACE devices ?I need this functionality to redirect the traffic when the servers at the primary site are down and the clients still hit the content at site 1The CSS config isserv...

Hello,does anybody knows if application authentication is possible on the ACE 4700 ?That means traffic to vip is authtenticated on a external ldap server. I didn't find any documentation. best regardsDietrich Schleyer

We currently have a Cisco CSS11501 which we have configured with SSL offloading.We offload the SSL traffic and after description of the ssl traffic we perform URL filtering.Can the Ace 4710 Appliance do the same?I have attached the current configurat...

I am getting an error message when i am trying to import certificate/keys to the ACE through device manager GUI.The error message says to do "ssh key rsa 1024" from the config mode.I tried to execute this command from the CLI and i can find this comm...

Hi,I'm having troubles getting HTTP acceleration to work on WAAS 4.1.1b.I have created a branch office topology with a 2Mb link with the data centre. Both locations employ a WAE-512-K9.When looking at the dashboard, I can see that traffic optimizatio...

Hi,Port 389 is configured on ACE to loadbalance to LDAP.Test clients runn ok for approximately 2 minutes and then fails. Then every other test fails, untill clear connection all on ACE is applied.Any suggestion as to what to check in this situatiobn,...

hi.when I issued "show mod csm 1 arp" command,what means is REAL or LEARNED of type?I think REAL is real server.I want to know means of LEARNED.thanks you.

Hi,I have a content rule to do weighted round robin load balancing among three web servers. I want to be able to direct traffic to ONE of these three servers if a cookie matches a regex. If there's no match, the traffic should be balanced between the...

Hi All, I have a couple of question regarding VB on WAAS: 1- supported platforms for VB are all x74 series or only 674? 2- for implementing VB, do I need to have two VB, one in central site and the other in remote sites? or only have VB in remote sit...

Hi,I am evaluating the ACE 4710 bridge mode for loadbalancing several services (http,ldap,smtp,pop3 and dns). The current configuration uses 2 L3 switches as the servers default gateway (using HSRP). I assume that in the bridge mode i need 1 vlan for...

Hi to all,Assume that inbound interface of FW1 side cable unplugged. In this scenario the probes are still up. Probes cannot detect this situation and fail over doesn't take place. As you can see it is impossible to detect cable tear down unless we h...