Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
My question is, will two WAAS devices still optimize traffic if one waas device has an enterprise license and one has a transport license? (For both WAAS 4.0 and 4.1)
I have a VIP that is not able to stream RTSP over UDP. TCP streaming works fine, but when I configure UDP on the Real client no UDP packets are even processed by the ACE. When I configure 'inspect rtsp' on the class, then TCP streaming also breaks. I...
Hi allI am new to ACE module in Cisco 6509. May i know how can i configure the ACE to access TFTP on my laptop. I have no problem accessing TFTP from the sup720 module.Please advice how to config the ACE to access the TFTP in my laptop. Thanks
Hi,I have a doubt about the SFTP configuration on CSS. If I would like to configure the CSS in transparent mode regarding to SFTP protocol. I mean, without configuring ssl offload on CSS.Moreover, is there a specific port that I have to configure for...
Good Afternoon, I have the following Content rule setup. content rrc-stg vip address x.x.88.18 advanced-balance sticky-srcip redundant-index 8812 add service rrc-stg-1 add service rrc-stg-2 port 80 protocol tcp url "//staging.rrc.x.x/*" activeservice...
Hi AllI try to use TCL script with CSM Netconfig.My script start with the tclsh command, but each time I try to use a function (ex.: while) that required to lets the brace open I have the following errorex.:tclshset x 0while {$x < 10} {+>missing clos...
Hi, I have 2xE1 bundled into multilink interface, ip wccp 62 redirect in on multilink only, ip wccp 61 redirect in on fast0/0. While both serials works - everything is fine and WAAS works smoothly. (4.0.19(b14) ). Problem appeared when we had lot of ...
IE on Vista does not work hitting ACE (ACE10-6500-K9 / c6ace-t1k9-mz.A2_1_1.bin) butIf we use the following browser (IE on XP, safari, Mozilla on XP or Vista), it works but if we use IE on Vista, we cannot access our website.
I just went to an existing client that I am taking over so I don't have a lot of details, but they are complaining that these three do not play at all together. They have made the IPS promiscious since it was causing high CPU when and are complaining...
I hope someone can provide some help, I need to deploy a CSM module for the purpose of Disaster Recovery, the objective is to be able have a standby server in site B so when the server(s) in site A fails to have the CSM direct all traffic to the stan...
Hi,This may be very simple question, but make me confused. How to change hostname,example: from CSS11503 (default) to may be like CSS-LB-01 because i must implement 4 CSS 11503.Anybody can help me ?Rgds,Jerri
Hi - I have a requirement to load balance traffic accross some servers where the load on each server cannot neccesarily be measured based on the number of connections to it. The ACA algorithm would have been useful for this, as would configuring DFP....
Not able to establish the IPSec remote access VPN from the inside zone of the firewall.Connectivity:Inside network is connected to the inside interface of the firewall. Firewall outside interface is connected to the CSSCSS is connected to ISP-1 and I...
