Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I have to configure a BMG = 256 kbps on ADSL link. I would like to use aal5 and ATM vbr-nrt class.The question is: the line command that I should insert is "vbr-nrt 260 260 1"? Thank you very much.Regards.Giuseppe
Hi all,I have a doubt about the IEEE 802.3ah standard regarding OAM frame on Ethernet in the first mile.The scenario is formed by an access switch and on the other side an ONT.The question is: if the ONT/CPE doesn't support this feature could I use ...
Hi all,I want to performe some tests about NAT features on Cisco 2821.If the configuration that I report here below, the host with IP address <host_1_on_VLAN_1> creates traffic to an host on outside with a different protocol from the one foreseen in ...
Hi Reza,thank you for your answer. It is a good solution but I have only two NICs where in one of these the traffic flows inbound, for example, on VLAN 1 and in egress on the other NIC belonging to another VLAN, for example, VLAN 2.Now, we have 4-5 s...
Hi Reza,sorry if I couldn't explain well but I don't know the reason because the VLAN has to be preserved.The important thing is if there is a way to performe that. I thought at VMPS or 802.1X but I'm not sure.Do you have any idea how to do that?Than...
Hi JK,thank you for your answer. I have another doubt because viewing the FW configuration I noticed that there isn't configured the vpn-addr-assign command but the vpn group is defined in "tunnel-group mygroup general-attributes" and moreover there ...
Hi,I used the feature navigator and I got to the same conclusion but my doubt is due to the fact that in my configuration there is Std Img with IP service license. Using the configuration tool there isn't EMI configuration for CAT3750ME. Moreover whe...
