Application Networking

Hi there! I have a client that is, perhaps rightfully so, pushing back against paying Cisco's price for hard drives for their WAE-512. The MSRP is like $1300 for a 250G SATA drive, so even with discounts the price is still pretty outrageous. The ques...

Hi, all servers for an application are to be downed for upgrades. During this time all clients are to be redirected to a "sorry" page, hosted on the web. I don't have a problem with this.My problem starts when the service is restored.The redirect mus...

We have WAAS running at both our data center and branch offices. We are connecting the WAAS device to the WAN routers directly and using WCCP for redirection. Some of our branch to data center traffic is running through GRE tunnels which begin/end in...

Hi all,I am looking into deploying WAAS at a couple sites and thinking about doing it on my own without going through a Cisco partner. I have heard stories that WAAS is simple and easy to deploy. Has anyone deploy WAAS successfully on your own withou...

Hi allWe are doing redirects on our CSS11501 already, but some of them we'd like to make permanent redirects (HTTP 301). Is this possible?Thanks

Hello! Is available 2 wae-612 (accelerator) and 1 wae-512 (CM) It is impossible to start in any way them in work. The scheme: net1 - freebsd1 - internet - freebsd2 - net2 .........wae1..................wae2 the Traffic on wae from freebsd is transfer...

I am migrating from a CSS environment to an ACE module in a 6513. I have an ACE context between VLAN29 and VLAN30 that is a DMZ. VLAN29 faces the firewalls and VLAN30 the real servers. I can access the servers with a serverfarm and a "vip". I need to...

What is the recommendation to achieve high availability (and load sharing?) using two WAE's in a DC with inline adapters being used for interception rather than WCCPv2? Any ideas greatly appreciated.

After the WAASs implemented in our site, I have showing up the WAAS standard report to manangement, but they want to have a report to see any improvement on the WAN in between 2 sites.Anyone know that which report or How to present the improvement af...

Hi,We have a couple of 11503 set in an active-backup configuration with fate sharing.They run NAT sucessfully changing web caches ips (behind the CSSs) into CSS redundant VIP when sending responses back to the clients, but sometimes, following a burs...

on CSS I get an info if a server fails the keepalive and get in state "down, up or suspended". This is logged in the traplog file on the CSS.Is there any possibility on an ACE to have logs for rserver state changes like "PROBE-FAILED, OPERATIONAL and...

Dear Folks,I 'd like to load balance 2 ASA using 3 ACE [ Inside,outside,dmz network zone]I 've seen sample configuration, all of them are running the ACE in the route mode, and asa are running in route modeWould it be possible to run the ACE in the b...

I have removed some of the network commands in my bgp router and when re-entered I do not see the whole command ie.beforebgp 654321network 10.1.1.1 mask 255.255.255.0after bgp 654321network 10.1.1.1why is there no mask statement in my command