Application Networking

Gurus, Had just deployed an ACE for my customer for the caching servers. We used URL hash and Sticky , after some monitoring we find that 1 server gets 15K connections, another one gets only 5K.Now its to be understood that due to the erratic ...

I believe I should be able to get into the management interface IP address of the ACE 4710 FT unit. However, I keep getting this message, "login is temporarily unavailable as startup configuration is being applied; try after some time ..."I even tri...

hi.i have a question.i have deployed my wan routers QoS without any software and now i have to deploy same one with QPM 4 and there is a problem.i want to assign a service policy to interface group async with qpm but it doesnt detect int group async ...

Hi, I would like to accomplish the following.www.xyz.com resolves to a VIP on the Cisco ACE 4700 on HTTP.When a client types in http://www.xyz.com/bcd, I would like the request to be redirected to www.bcd.comHow do I go about doing this? Do I need t...

I have run into an issue that i believe is file server related however i just want to run it by the board for clarification. A remote site was recently converted from a standalone server site to one that is supported via WAFS/WAAS 4.0.11 installed on...

Hi,I am having problem with my WAAS which is unable to get sync with the CM or the remote peer. I have tried forced all devices with the same timezone & even manually set the device clock by " clock set" but however I still see the minor alarm from t...

Hi,I would like to implement Source-NAT for some traffic, but not all traffic for the ACE 4700. The ACE 4700 will be configured as a bridge.Can I configure Source-NAT using an extended access-list when the ACE 4700 is used as a bridge? I need Sourc...

After upgrading IOS 12.2SXD ->12.2SXF on both 6500, the CSM 4.1(6) displays the following message :router#sh MODULE CSM 8 FTFT group 1, vlan 930 This box is active Configuration is out-of-sync priority 110, heartbeat 1, failover 3, preemption is offA...

Hi, on the CSS can a static host route override routing to directly connected subnet?Thanks-serg

We have a web app that still uses frames. The web URL is HTTPS, but 1 of the frames uses HTTP. I need for a user to stick to the same server for both frames or it screws up the application.I am load balancing to 2 servers over HTTP and HTTPS using ...

Hi,how can I modify a global keepalive on a css 11500?!I mean, I have create a keepalivees:keepalive concors_ris type http frequency 10 uri "/risultati-concorsi/"I want to modify this keealive, but I cannot.I also cannot remove this one.Can anyone he...

Hello all,I have a CSS11506 with the following config...!************************** SERVICE **************************service pas_main_uswrnsa0ptf01_11111 ip address 172.16.25.30 keepalive type tcp keepalive port 11111 port 11111 activeservice p...

Has anyone out there had any experience deploying a VDI solution that can take advantage of Cisco WAAS. I have read that WAAS can accelerate RDP when the default compression and encryption for RDP has been turned off. Is the performance comparable to...

We have two routers running the same IOS version in our core - c7200-is-mz.123-10a.bin. One terminates a number of tunnels and the other has a number of dialer interfaces associated with an ISDN PRI. Each of our site routers has a tunnel going to t...