Application Networking

Hi Netpros,we use our 11503 basicly for webserver loadbalancing - of course it works quit well.now we need to balance 2 new webserver systems, but this time all requests should go to one server and only if this one fails the request should go to the ...

Hi Folks,We are going to be piloting a web content filtering product and want to use it with WCCP. Due to equipment and lab restrictions, we have been unable to fully test the entire solution in our test lab and are concerned that we may encounter pe...

Hi,Is it possible having cat6k with CSM module to configure them with SVI vlan for some hosts and server vlan for vserwer and real servers behind it to assure one to one communication between them?I need to connect from SVI vlan hosts to every host t...

I have a question about designing a failover for SMTP server between HQ site and DR site.I have web servers failover using this CSS.I have a one armed config and cannot change it, I am using "add destination service" for the web servers and it works....

Please direct me in the right direction on how to log the client requests for load balancing? I am looking for something similar to the show flows but with timestamps.Thank you,tj

Hi,I would like to know whats the difference between operational,locked and active version.Is it possible to change the locked version to another version?In the upgrade manual says that i can't remove the active version or the locked version. Then I ...

Does anyone knows where i can get access to some online resources for Cisco WAAS products / technology??Would appreciated any help.

We have four isp routers and one CSS connected to a layer 2 switch. The CSS is configured with four equal cost default routes to the routers. Since all incoming traffic is entering from the same interface of the CSS, how does the CSS know which route...

We are going to be evaluating Cisco's WAAS technology soon. I've heard conflicting information on the central manager - some say that a central manager is required, and others (including some of Cisco's documentation) state that the WAE can be config...

guys please help...i have 2 servers setting behind CSS 11503 working as load balancing and it has SSL module...all https requests comming from windows xp IE version 6 or 7 is working fine, but when try from Vista IE it's not working,is this problem r...

Hi, We are forwarding Symantec replication traffic via our WAAS infrastructure over a 20Mb WAN link. The CM appears to register the traffic but does not optimize it at all. Has anyone had any experience with WAAS and Symantec Veritas Volume Replicato...

I'm seeing a bunch of hits for "Peer received reset from end host" on all of my WAAS devices (mixture of edge NM-502s and WAE-512s, with a core cluster of WAE-612s) when I do a "show stats tfo" in WAAS 4.0.13.Does anyone know if this is really a prob...

If a central manager is being run in a warm standby mode (one primary, one in standby), and it becomes necessary to promote the standyb to primary, my understanding is that the system then restarts itself. Once this happens, does the primary change i...

hello, is it possible to check the health of a ssl-server with a keepalive of type get https://server/index.html, all this without a ssl-module installed ?