Application Networking

When I put the one of the real servers in outofservice mode, slb works. But when I put the server switchport to shutdown to simulate server down, slb does not work. It keeps on trying to look for the server that it last established the session with a...

VIP: 10.1.1.1:80real service 1: 192.1.1.1:80real service 2: 192.1.1.2:80user IP: 10.2.2.1CSS ver 8.2when user opens a web-browser connection to http://10.1.1.1, he always gets attached to 192.1.1.1 unless he closes the browser and opens a new one onl...

Does GSS has an enable password?Please advice

We have had a CSS in place for about two months now.The CSS is configured in one armed mode with groups and "add destination service X" configured for our server.Since we have implemented the CSS the hit count on the server has gone down from 200,000...

HiCould someone inform me how a CSS 11500 handles a packet with TCP invalid checksum. I have two loadbalanced svrs behind a CSS and im seeing the and ACK with a bad checksum hitting the server VLAN interface of the CSS which appears to send RST 200 m...

Hi,I have a problem with the configuration of the Serverside alias IP Address. When I configure the IP Address of the Server Side Vlan to .1 everything works fine. But when I change the Vlan IP Address to .3 and confige the alias IP Address to .1 I c...

Hello,I would like to know the recommended list of router + IOS version to deploy load balancing using WCCPv2 with squid web caches or cisco WAEs, initially in a test environment and later for a production environment.I have used the following router...

Is it possible to get a CSS switch to load balance servers that are not directly connected. I have tried to do this for Web servers but without success. If the servers are directly connected it works fine, but if they are connected to a layer 2 switc...

I have 2 CSS 11501, and they work fine.The only problem that has is that it doesn't work one of the content HTTPS.This is the configuration that I have:......................................service server54 ip address 172.16.10.46 keepalive port 443 ...

I have inherited a used Cisco Css 11000 from a friend. I am trying to set up a test environment to get a jump on my classes this upcoming semester. So far I have had no problems setting it up to load balance connections between four "servers". But i ...

Hi,We are using CNR for DNS and DHCPv6 and would like to handout v6 network prefixes of /119 or /120 to Windows 2003 (SP2) clients. Question is will the MS 2003 clients accept a network prefix of other than /64? (Sorry I understand this is NOT an M$ ...

I configured cookie sticky and it seems to work by testing from the same machine with different browsers (IE & FF). I also can see the connections using the show conn serverfarm command. But I can't seem to see the sticky database entries. It is alwa...

How does the ACE module recover a real server that has entered a probe-failed status state? We are doing some testing, purposely dropping a servers interface. ACE recognizes the server as being down and show it in a probe-failed state. When we bring ...