Application Networking

Hello,currently moving from server-based certs to CSS/SSL based.We have two sites, two CSS/SSL on each in ASR mode.There are two real servers behind each SSL rule for load balancing.The question becomes how many certificates do we need for such desig...

Hi allI'm fairly new to CSS so apologies if this is an aobvious question...Do I need an ssl module to load balance https requests using certificates on the servers themselves, simple round robin, two web servers, setupregardsnigel

I am a rookie with the the CSS so excuse my novice question...Can the CSS 11501 load balance provide load balancing for different networks without routing between the two networks?For example, if I am load balancing for two vlans on the CSS, vlan-a a...

Hi,We testted two scenario :1. Client creates request directly one application server.2. Client created request using CSS 11503 VIP addressResults from client's side report:------------------Using Directly server IP Address:TPS: 128,639Response Time:...

A client wants a Caching solution for their GPRS network. We want to propose Content Engine 566. The Clients requirements are;a) Support Transparent Proxyb) Support for HTTP, FTP, Gophers and SOCKSc) Support for Secure Connection (Transparent HTTPS)d...

dear all,I have prepared config for load balancers connected in ASR mode with two ISCs as follows:Kindly take a look and let me know if further changes required. I want to load balance http traffic. I don't have lab-setup to test the same and prepar...

Hi all,We have to provide solution for upcoming content provider. Basically we want to load balance SAP and Siebel servers.We are going to use four LoadBalancers in ASR mode with active-standby, Two for SAP servers and two for SIEBEL.for the sake of ...

Hi Guys,can anyone confirm or point out errors in this config that I wish to pop on our 6509. We don't have a test environment, so I need to get as much feedback as I can on this.Thanks in advance,Jamesno natpool WSB_RADIUS 10.176.57.115 10.176.57.11...

Hi,Is it possible someone can let me know if the management port on the CSS is out of band? I am assuming it is but haven't managed to fine this in the docs. Thanks

See the screen attachements for details:3 sites (locations) with each 2 Cisco routers, between 3 communication lines.problem = howto configure te site when there is one communication line failing. The communication must go via the other communication...

Is this announced Modul the before mentioned NextGen CSM?http://newsroom.cisco.com/dlls/2006/prod_041006.html?CMP=ILC-001

Hi,I have been having a few problems with NAT and gslb.The scenario is as follows. I have two sites with one gslb in each location using rule based dns.. the dns and vips are statically nated behind pix using the static dns attribute.If I do a looku...