Application Networking

CSS 11506 sitting in front of mainframe and two Windows 2003 serverscontent rule3056gifadd service web1add service web2vip address 10.10.200.252balance acaurl "/IMAGE_DIRECTORY_NAME/*.gif"port 3056activeA small number of page requests, that do not ma...

Hi, Can anyone tell a poor fool like me how to enable SNMP traps and set the trap destionation on a GSS ? Can't find it in the documentation. Thanx alot Georg

Hi, how does the CSS decide which service a request is sent to when using 'balance srcip'?The documentation states: 'balance srcip - Source IP address division algorithm. The CSS directs all client requests coming from the same source IP address to t...

Hello all,Would appreciate some insight on a issue I'm facing when trying to configure a CSM in a 6513 with a Firewall Module.The FWSM has IPs in all vlans and is in routing mode, also it is the default gateway for servers in all VLANs.There is also ...

Hi Guys,i did a test on a set of Load Balancer, which is currently being setup. VIP address is 192.168.11.77 and web server is 192.168.11.48. Port from web server is 8080. When I telnet to 192.168.11.77 thru port 8080 and try got get a page thru comm...

I have a CSS 11503 set up in a DMZ that is load balancing 2 Netsilica proxies. All worked ok when I used Sticky Scrcip.We are also using Akamai externally, they said clients ip may change during use. Tried to use arrowpoint cookies.servicestrig xyzco...

Hi,I want to enable multicast on Loadbalance Isit possible.if yes how.

We have a cluster of MS terminal servers (5) behind a CSS and recently we have experiencing disconnects from a existing terminal server session. We have this config running for more than 2 years now and never had any problems with it. The only thing ...

Hello,We have a CSS11050. I'm looking for documentation on how to configure two CSS devices to support each other for failover capability. I tried searching the forums, but only found server LB, failover''modules, etc..., but what if the primary CSS ...

Can someone confirm: When a service hits the CSS, the match made to a source group is ONLY on the IP address, not port/protocol/IP..right?In other words, I can't specifyservice www1-tcpprotocol tcpip address 1.1.1.1and service www1-udpprotocol udpip ...

A general question. When you specify a flow permanent port..will that apply to only ingress traffic with a matching destination port, or would a matching source port also apply?Is this true for content rules also?

Dear Friends: I try to config aggregate mode for CSM，and I can't find sample config on CCO，anyone can help me!?THKS

Hi,I've deployed a transparent caching solution with several CE560 and NM-CE on r3745. The CEs are running ACNS 5.2.3 and I have three sites using ACNS 5.2.5 for testing purposes.Everything is working fine, but now I face the following issue.On sever...