Application Networking

Can I configure my CE590 with a private address ( for ex. 172.16.1.1 )Should I translate this private address to a public address ?The sample configuration in the below URL comment :!---Important: If you configure the Cache Engine!---with a private a...

hi,i wonder if 302 ( move temporaily) for return code in dynamic client by-pass. but it said 200 in the Cisco web page, why?thanks difei

hi,who can tell the link to the user guild of CDM, for ECDN maybe?tks /difei

We use HP openview as a monitor for our SNMP traps.I have a couple of CSSs in my network, and i am not using the management interface. I would like to change the SNMP source interface to a fastethernet interface instead of the management one, so open...

What's the best way to go about troubleshooting a relatively highCPU load on an SCM module? Memory doesn't seem to be an issue.I've seen CPU rates spikes of up to 98% gates(config)# sho system-resources System Resources for 7/1: Installed Memory: ...

We are load balancing two web servers using two CSS11155 on a box-to-box redundant configuration. To be able to monitor the behaviour of the solution we configured SNMP on the devices and are using MRTG to retrieve some MIB variables values relevant ...

Because I couldn't find any document describing how to manipulate the configuration on a SCA 11000, I wanted to ask whether a 'copy running-config tftp://servername/filename' is enough to backup the config (including certificates and keys). Can we r...

It is possible to make backup of the CSS11051 operational system?I can make a copy of the configuration, but not of the operational system. Does exist a command like "copy flash tftp" as in IOS devices?

I'm trying to use a sniffer to capture traffic that is hitting my CSS and what services are requested/handled inside the CSS network. I have redundant CSS with 2 LAN switches (cat.2924XL) behind it. I'm running port monitor on all the internal con...

Hello,Pursuant to a previous post I made about using the CSS as a proxy for our web servers, one solution proposed was to utilize the reverse-proxy functionality of the CSS. One issue I have with this setup is that we don't need the extra proxy serv...

Does anyone know what needs to be done on the service/content rule configuration to support Winsock Proxy requests from client to VIP for load balancing to work?

If a failover occurs from the primary to secondary local director, what is the state of the config on the newly active standby device. During normal operation, I believe the standby device only stores the config in memory. Does this mean that if it...

hi,for WCCP v2 dynamic client by-pass feature, what's the return code send from CE to client? i guess 302 -- redirect?thanks /difei

We currently have CSS 11154 running within our test environment. I have issued the "no restrict web-mgmt" command with facilitate device management via a browser. This seems to work fine when I access the device via one of the vlan interface of the C...

I have a 9GB Hard Disk on a cache engine at the moment, but 18GB was ordered. We had to install it before the other 9GB arrived though, and now it's arrived, I need to put that extra 9GB in. I have been surfing the Cisco site trying to find instruc...