cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1591
Views
0
Helpful
5
Replies

WAAS - wccp L2 setup

Srin_G
Level 3
Level 3

Hi all,

Please see the attached diag for our waas setup. The traffic is not optimized and shows as pass-through in one end and no stats are shown in other end.

4500 switch config:

ip wccp 61 redirect-list wccp_list password xxxx

ip wccp 62 redirect-list wccp_list password xxxx

Interface Gi1/1

ip address 10.1.46.1 255.255.255.252

ip wccp 62 redirect in

!

interface vlan 170

ip address 10.46.170.10 255.255.255.0

ip wccp 61 redirect in

!

ip access-list extended wccp_list

permit ip 10.46.170.0 0.0.0.255 any

show commands:

sh ip wccp
Global WCCP information:
    Router information:
        Router Identifier:                   10.46.1.1
        Protocol Version:                    2.0

    Service Identifier: 61
        Number of Service Group Clients:     1
        Number of Service Group Routers:     1
        Total Packets Redirected:            150487
          Process:                           0
          CEF:                               0
          Platform:                          150487
        Service mode:                        Open
        Service Access-list:                 -none-
        Total Packets Dropped Closed:        0
        Redirect access-list:                wccp_list
        Total Packets Denied Redirect:       0
        Total Packets Unassigned:            0
        Group access-list:                   -none-
        Total Messages Denied to Group:      0
        Total Authentication failures:       2
        Total GRE Bypassed Packets Received: 0
          Process:                           0
          CEF:                               0
          Platform:                          0

    Service Identifier: 62
        Number of Service Group Clients:     1
        Number of Service Group Routers:     1
        Total Packets Redirected:            232994
          Process:                           0
          CEF:                               0
          Platform:                          232994
        Service mode:                        Open
        Service Access-list:                 -none-
        Total Packets Dropped Closed:        0
        Redirect access-list:                wccp_list
        Total Packets Denied Redirect:       3685761
        Total Packets Unassigned:            0
        Group access-list:                   -none-
        Total Messages Denied to Group:      0
        Total Authentication failures:       0
        Total GRE Bypassed Packets Received: 0
          Process:                           0
          CEF:                               0
          Platform:                          0

3750x switch config:

ip wccp 61 redirect-list wccp_list password xxxx

ip wccp 62 redirect-list wccp_list password xxxx

Interface Gi1/0/1

ip address 10.1.46.2 255.255.255.252

ip wccp 62 redirect in

!

interface vlan 170

ip address 10.45.170.10 255.255.255.0

ip wccp 61 redirect in

!

ip access-list extended wccp_list

permit ip 10.45.170.0 0.0.0.255 any

show commands:

sh ip wccp
Global WCCP information:
    Router information:
        Router Identifier:                   10.45.1.1
        Protocol Version:                    2.0

    Service Identifier: 61
        Number of Service Group Clients:     1
        Number of Service Group Routers:     1
        Total Packets s/w Redirected:        62
          Process:                           15
          CEF:                               47
        Redirect access-list:                wccp_list
        Total Packets Denied Redirect:       0
        Total Packets Unassigned:            0
        Group access-list:                   -none-
        Total Messages Denied to Group:      0
        Total Authentication failures:       0
        Total Bypassed Packets Received:     0

    Service Identifier: 62
        Number of Service Group Clients:     1
        Number of Service Group Routers:     1
        Total Packets s/w Redirected:        0
          Process:                           0
          CEF:                               0
        Redirect access-list:                wccp_list
        Total Packets Denied Redirect:       795
        Total Packets Unassigned:            0
        Group access-list:                   -none-
        Total Messages Denied to Group:      0
        Total Authentication failures:       0
        Total Bypassed Packets Received:     0

Traffic is shown as pass-through in 10.46.40.20 and there is no tcp connections shown in 10.45.40.20! Any inputs?

Regards

1 Accepted Solution

Accepted Solutions

Giovanni Dambrosio Ocampo
Cisco Employee
Cisco Employee

Hello, Srini:

I saw  that  you are  using a 3750 and a 4500, which of the  2  is at the location showing as PT?

Please check that the 3750 is using the SDM template as desktop routing, otherwise the WCCP packets  are not going to be  redirected.

One  useful command is the "show ip wccp 61 detail" it will show  you what is the negotiation of  the WCCP features.

When you see a connection on one  side  and  not on the  other, most likely the  traffic is not reaching  the  other WAE with the  TCP options, this could be  due to:

1-firewall blocking the tcp options.

2-wccp redirect list avoiding the optimization.

3-By pass list on the WAE.

Please let me know if It helps.

Best regards.

Giovanni DAmbrosio

View solution in original post

5 Replies 5

ajayku2
Cisco Employee
Cisco Employee

Hi

Please test after removing the password option:

ip wccp 61 redirect-list wccp_list password xxxx  <<------

Also see if there is a firewall at the edge. Normally most of the firewall remove the option header.

Let me know how it goes.

regards,

Ajay Kumar

Srin_G
Level 3
Level 3

Thanks mate.
There is no firewall in this setup as shown in the diag.This is the first time we trying layer 2 setup and also how does the wccp authentication work if we remove the password in the switches?
Thanks

Sent from Cisco Technical Support iPhone App

G'day Giovanni,

The waas plugged in the 4500 shows PT no peer and the 3750X doesnt show anything at all.

I checked the 3750x it shows it is using desktop routing as the template.

Below is the output from 3750 about wccp 61 detail:

#sh ip wccp 61 detail

WCCP Client information:

        WCCP Client ID:          10.45.40.20

        Protocol Version:        2.0

        State:                   Usable

        Redirection:             L2

        Packet Return:           L2

        Packets Redirected:    62

        Connect Time:          3w1d

        Assignment:            MASK

I can see the matches in the redirect list but nothing shows in the WAAS being optimized.

Extended IP access list wccp_list

    10 permit tcp 10.45.170.0 0.0.0.255 any (76 matches)

    20 permit tcp any 10.45.170.0 0.0.0.255

There is no firewall or bypass lists involved in this setup.

regards

Giovanni Dambrosio Ocampo
Cisco Employee
Cisco Employee

Hello, Srini:

I saw  that  you are  using a 3750 and a 4500, which of the  2  is at the location showing as PT?

Please check that the 3750 is using the SDM template as desktop routing, otherwise the WCCP packets  are not going to be  redirected.

One  useful command is the "show ip wccp 61 detail" it will show  you what is the negotiation of  the WCCP features.

When you see a connection on one  side  and  not on the  other, most likely the  traffic is not reaching  the  other WAE with the  TCP options, this could be  due to:

1-firewall blocking the tcp options.

2-wccp redirect list avoiding the optimization.

3-By pass list on the WAE.

Please let me know if It helps.

Best regards.

Giovanni DAmbrosio

Sorry mate, I should check my eye sight the sdm template was pointing to desktop-default, changed it to routing and it worked as a charm.

Thanks for your help.

Review Cisco Networking for a $25 gift card