Cisco Bug Discussions

I have confirmed this issue still occurs on my 3850s with Denali 16.5.6 and Everest 16.6.3.  Is there any other work around that does not involve rebooting the switch?

Dear community i want to know if this same bug but with the version 6.2.3.3. from Cissco Firepower   Cause i check the FTd and i didnt see any issue, the healt its work properly.       Regards

Hi Guys   I also encountered this issues, my device is the N7710 firmware version is 8.2 (1), is it possible to solve it other than reinstalling the module?   show int status | i Eth1/6Eth1/6 -- faulty 1 auto auto 10Gbase-SR   Ethernet1/6 is down (Ha...

Hello all,   I'm matching this specific bug here CSCvb71114 but with Prime Infrastructure last release 3.4.0.0.348 (Device pack 1 applied too).   Is there some workaround for this ?   Do I have to downgrade to 3.1 patch 5 cause it's a fix release ?  ...

is this enhancement present also in 7.3.2.N1.1?   regards, Nick  

Reported this way back June, still no fix even on the new 6.2.3.5 release.

Is this bug configuration dependent?

  Grep works a little odd compared to Linux, but it works to filter many things.   (wlc) >grep include Not "show ap join stats summary all" Press any key to continue..y 18:8b:9d:dd:a7:60    18:8b:9d:e3:5a:b0    r039-ap003              10.24.209.22   ...

Can someone help me with the exact software version of v Edge 1000 and v Edge 2000 appliance that is being affected with this. I see the status of the Bug to be fixed. Is Cisco going to release the fixed software in near future?

In our organization, we've encountered this issue on the following hardware platforms, when loaded with software versions CE9.3.x/9.4.x/9.5.x. Our workarounds:- Roll software back to CE9.2.x for certificate upload, and then roll software forward to 9...

Any reason why clients on 3802 AP reports only CCX version 1 with no E2E support? Other earlier models report CCX version 4 with E2E support??

This caveat has been labeled an enhancement, but is clearly a bug.  Who expects their WSA to become unusable if it fails to get an update?

We've updated our ASA to 9.9.2(18), which should have solved this bug (https://www.cisco.com/web/software/280775065/142220/ASA-992-Interim-Release-Notes.html). I'm unable to see how to configure this values for our WEBVPN. Somebody a suggestion? 

I have found in software version below anyone have solution for fix it?   version 13.2(2l)