Cisco Bug Discussions

Hello, I am facing similar issue. There is nothing wrong, when I check CIMC GUI, but I see some warnings using IPMI: 40  | PSU1_AC_OK       | Power Supply    | Warning  | N/A        | N/A         | 'State Asserted' 41  | PSU1_PWRGD       | Power Supp...

Does anyone else have this issue in ICM 11.6, CVP 11.6 and Finesse 11.6?

Here some additional background information as a summary ==============================================   Problem: "Exceptions for particular server certificates not possible" --------------------------------------------------------- One of our partn...

Hi all   This bug listed itself as Fixed, but it does not list a Fixed-in Version, does anyone know if there is one?   Thanks.  

Hello!   For Catalyst9300, default is 2048, and cannot bring it lower. Any ideas how to make prime compatible with Catalyst9300? ----------------- sw-c93(config)#ip ssh dh min size ?  2048  Diffie Group 14 2048-bit key  4096  Diffie Group 16 4096-bit...

1. What caused this bug?2. Is the problem-solving image released rather than manual processing?3. Has the Nexus3000 series also had symptoms and improved images were released?

So does this affect only the 16.7 code train or every IOS XE version (16.x and 3.16.x) before 16.8?

Workaround:Save the configuration of the switch. Plug out the power cord. Plug in the power cord. Every port works again.

Anyone who knows anything about NTP would NEVER want (2) NTP servers, as the system will not be able to determine which time server is accurate since there is no majority. You should either keep the software the way it is now with (1) NTP server or i...

Hello,   I've been hiting this bug CSCvd03961 and i don't want upgrade ios because i'm remote so i'm trying to apply workaround:Enable service local directory and also provide url service under voice register global   I tried  url directory http://X....

Hi,   Refer to the bug documentations, there is a lot of affected version on this vulnerability and it doesn't have any fixed release for it. Any idea on the workaround or fixed release on FMC?   Current FMC and FTD version : 6.2.3   Does it impact t...

I am tried to power on a server but it alwayts hangs up on check if power can be allocated to server, What do I need to do?   On CISCO UCS B200 M4

END Button missing after a Consult call. Scenario where the End button is not shown:Agent A is logged into Finesse Desktop. Agent B is logged into Finesse Desktop.User A is an external PSTN.User A calls Agent A. Call gets connected.Agent A makes a Co...

Hi,Can anyone confirm whether is there any fix for this bug ?

Hey,   When moving customers from 8710 (AGC support) to CMS, we get reports of volume difference between endpoints/devices connected from a one room standpoint.   It was quite a surprise when TAC confirmed there is currently no AGC support on CMS.   ...