Cisco Bug Discussions

Affects 14.2.2 too

Hi,affects 14.2.2 too, is there any progress?

Is there any further information on this? The group is a security risk and is always conspicuous in the audit. We would like to have this group empty. Why does the ISE need membership in the group? Is there another possibility? So far I have not foun...

I use 12.5.1.13900-152 and it just happed today.I cannot get any report from hunt pilot which I just used it last month.even I use Chrome, Edge or Firefox or on Private, Incognito mode don't help.

Another workaround - moving a WAP to a different WLC and back also clears the issue (no reboot required)

Hello, We made and backup and restore at ADE-OS level for our Cisco ISE appliance. After logging in we can not see live logs anymore.  Already regenerate the ISE Root CA and ISE Messaging Services CA and also tried to disable the "Use "ISE Messaging ...

Also seen on an MDS 9132T 8.4(2b) to 9.3(2a) nondisruptive upgrade

Why is this showstopper a sev6? Is there any new information? Can we get more information on this ticket. My customer plans on going to PCCE 12.6.X and then upgrade their CUCM to 14.0 SU3. 

Does the current version of DNA Center 2.3.7.0 fully support AES256 over SNMP v3?

With router image XPedite5205-IOS-1-15.9.3.M1.bin, the CPU Hog failure could be induced with the command 'test cpurmi hog simple 1'But after upgrading the image to c5930-adventerprisek9-mz.SPA.159-3.M6a.bin, is there a new way to induce CPU Hog failu...

Hi !I have an issue on CISCO7609-S Version 12.2(33)SRC1.Given this simple config :int Te9/2.4000encaps dot1q 4000xconnect 10.10.10.10 10104000 encaps mplsbackup peer 10.10.10.11 10114000backup delay 10 30mtu 9100When UP with primary peer, MTU is 9100...

Why some features are only available in GRT (route-server, additional-paths) and not in VRF adress-family ?OK when the features are relative to MPLS labels distribution, but NOK for IP-only features, this breaks router virtualization.  

We had a trunked uplink port G1/1/2 admin shut. After reloading we got this error message. Running Cisco C9200L-48P-4G running 17.3.3. This was in a stack of 4 9200s. Had to disconnect all cables and stack cables, switch booted up like normal. So 17....

The workaround doesn't seem to be viable as the impact of this issue is felt already and it's not possible for us to know the domain of the captive portal to be added to theUmbrella Proxy Exclusion list in advance.We typically receive reports of conn...