I could not read from the bug information page if it applies to the bug, so please let me know. I am using ASA 9.16(2)14, does this apply to this bug?If so, is there no solution in 9.16(2) and do I need to upgrade to 9.16.(3).15?
Forum Posts
Hi All, With reference to the following bug ID:- CSCwd20481 - Command "reload cancel" fails when the system clock changes to a later time in between "reload in x" We ran into this bug today on a Cisco 9300 series Switch running IOS version 17.3.4. W...
Experiencing the same issue with a brand new Prime 3.9 install when trying to register using smart licenses. "Registration failed due to Communication send error."
Hello, In the context of this vulnerability, does anyone know how to get this fix for windows:4.10MR7 (4.10.07061) ? Cisco AnyConnect Secure Mobility Client Software for Windows and Cisco Secure Client Software for Windows Privilege Escalation Vuln...
This issue is still not resolved in version 4.0.4bdc04-ucsm02-B# show system versionUCSM:Running-Vers: 4.0(4b)Package-Vers: 4.0(4b)AActivate-Status: ReadyUCSM Service Pack:Running-Vers: 4.0(4)SP0(Default)Running-Modules:Package-Vers:Activate-Status: ...
Workaround to BUG: CSCwa22766: 1- Verify the virtual licenses usage by running below: OmniQuery.pl -db mdb -e "select * from smart_licenses;" You should see VIRTUAL licenses for the uuid of the FMC only 2- Remove the virtual licenses for FMC by r...
Hi All, Can anyone please confirm if CVE-2023-20178 affects 4.10 and earlier or just 4.10 version and 5.0? In addition, if I look into bug info, it affected only two version 4.10 & 5.0 whereas in advisory affected ones as 4.10 and earlier. It is real...
Hello all, I have 2 scheduled reports that run every morning without fail. However, I can not find either of those reports in the scheduler. My goal is to remove the report, because the users are complaining about too many reports. Any help would be ...
a client has the same error while the agent had been "idle" since it was put into 'Not Ready' state 2 minutes, 30 seconds ago. how long is the "Idling" state considered typically? because 5-10 minutes can be normal.
Cisco ISR4331/K9IOS current version: 17.6.3aTrying to upgrade to: 17.06.05 from Vmanage: 20.6.5 maintenance->upgrade sectionError showed:"Cannot determine current boot partition on device "
Hi. I still experiencing the EIGRP routes stale in the ACI even after upgrade from 14.2(3j) to 14.2(7f). Can verify is the version already solve the issue?
Hello, I can't reach a VIP through ICMP, even trying to do ICMP tests from the DNA CLI I can't reach the VIPs, has anyone been able to solve this problem?
Think you should change the middle prefix to 172.16.0.0/12 ... in the workaround
Hi,we have a switch in stack of 8 switches and recently we get this messages.SISF_DB_IOS_ERR: Unable to add/update new binding for mac XXXX.XXX, address XXX.XXXX.XXXX.XXX, zone_idSISF_DB_IOS_ERR: sisf add or update record error (Not enough space)SIS...
Dears, Is "crypto key generate rsa ...", generate a the workaround of this bug?
