11-02-2022 05:20 AM
Hello to all,
I am coming back to you because I have a new problem with my switch recognition in CBD.
It recognizes a lot of switches but some are categorized as blocked (Icon with a red circle in the topology). Could you tell me why and how to put them in Enable status?
And because of this they don't appear in the "Inventory" list.
Thank you in advance for your help.
Solved! Go to Solution.
11-04-2022 12:34 AM
Hello Thany you for you response.
The problem is resolve, I juste reboot the machine and now it's work.
Thank you
11-02-2022 07:03 AM
Blocked means, this could STP loop in the network (this is just guess only)
can you post the screenshot for us to understand the issue.
check any port-security enabled :
11-02-2022 03:55 PM
Actually this is due to the new Discovery Filtering feature in 2.5.0. If you open up the network details panel, you should see a Discovery tab. Have a look at that and see if you have entered any IP address ranges. By default, there is no filtering applied, but if you set any IP ranges here, then devices that are detected outside those ranges will be marked as blocked, hidden from the topology and inventory, and will not be actively monitored.
Cheers,
Dave.
11-04-2022 12:34 AM
Hello Thany you for you response.
The problem is resolve, I juste reboot the machine and now it's work.
Thank you
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide