Hi, I'm trying to install APIC-EM in home lab. I did steps below, but the installation got frozen (see attached printscreen). - provisionned VM on ESXi 5.1- downloaded APIC-EM-1.6.4.30024.iso- attached the iso file on CD/DVD Drive- started VM- frozen...
Hi Guys, Do we add TOR and DC switches to DNAC for management and inventory purposes or it is solely for Campus Switches ? ( Border and Edge)What is the best practice?
Good Day!I'm trying to configure the switches in my campus fabric but I cannot push the configuration through DNA, even I have configured the SNMP, CLI, SSH username and password and assign all of these to the site but still can't push the configurat...
If customer require a network deployment, DNAC is deployed in data center, WLCs and CMXs are deployed different sites across country? How to plan and calculate the bandwidth of the wan link between them? Do we have the guide on this? How to plan and...
Hi, I'm following the guide of "Cisco DNA Center Automation and Assurance v1.3.1 for Partners - Instant Demo". On page 15 number 9, I can't find "iOS Analytics" option to the right of RF. On page 17, I can't find "intelligent capture" to the righ...
I am pretty new to packet tracer and networking as a whole and I am not sure how to configure my DMZ and firewalls. So I have 2 firewalls and a DMZ server between them. Any help will be appreciated. Thanks in advance!
So basically, I have this network where I have 3 floors of 10 PCs where the staff members are from different departments. I have managed to set up the dhcp and subnets but for some reason I cannot access the servers. Not even able to ping them.
need to reset switch Cisco 9300 to factory settings but i press the mode bottom when plug it in power and waited till i enter the enable mode in the switch and nothing is happen , is there is steps to do reset
What the case is that the count is more than one in command output of show license usage for C9300?According to CCO Doc for smart licensing, there is example for show license usage.the output for DNA advantage,,, the count is 3 for authorized status....
Hello, I have tried to provision a new site to a wireless controller in DNA center but it has been in a pending state for +12hrs and seems to have stalled. I have attached a screen shot of the progress view for deployment. Can anyone offer any solut...
Hello, I'm facing a big problem with my DNA center 2nd génération appliance. My Appliance was shiped with pre-configured software 1.3.0.6 and now it'is upgrated to 1.3.1.5. All functions seem to be installed correctelty and no hardware problem. t...
When upgrading DNAC System platform in preparation to Upgrade to DNAC v1.3.3.3 System upgrade stops at 1% with the following error
Apr 08 16:15:19 maglev-master-1 maglev-hook-installer.sh[8459]: | 2020-04-08 16:15:19,133 | INFO | 8475 | MainThrea...
