HiI am trying to work out the best/most efficient method to get clients migrated from old switches to new ones in SD Access. I have a requirement to maintain much of my address space so I need to have a scenario where clients can be on the same subn...
Does anyone know how to do a wildcard search in the client list in DNAC assurance. I can't figure out the syntax. I want to create a filter something like "AP Name contains "Floor-6" and see all the clients connected to all of the matching APs. I ...
I am experiencing issues with the Plug and Play process for provisioning new Access Points to Wireless LAN Controllers. Specifically, attempts to provision CA9126 to C9800-CL-K9 fails. PnP is failing in production so I am testing that on separate env...
Looking for any information on catalyst center integration with infoblox bloxone which is an cloud IPAM solution. Anyone have integrated Catalyst Center and Infoblox bloxone right now ? It seems that integration is only supported for on-prem Infoblox...
Hello,I am looking for some advice on how to run a particular type of report / audit within ISE. For some backstory, we are experiencing some issues with high CPU & Memory. We are also finding there is a lot of latency within the database.We currentl...
Hi Team, Just want to know how do you identify Airgap version from about in DNAC? Will it show Version with Airgap example Version 2.2.3.3 AirGap ? Thanks
Hello there, I am in the beginning of a new SDA deployment and I face an issue. DNAC is not pushing NAD's to the ISE during the border nodes onboarding. We checked the FW ports and the required flows seem opened. The integration between DNAC and ISE...
Hello there, I would like to know how are the different ways to onboard a border node to the DNAC, I mean the way that the device will be added on the inventory, not how it is added to the fabric. For me there are basically 2 ways : - manually config...
Hi!Trying to add a switch-network profile to a newly created site, like many times before. Pushing "sites", mark the new site checkbox, and Save. But now page is just "flashing" when pushing Save button, and nothing happens. It does not get marked in...
Hi All, I am planning to have a Catalyst Center but my switches are in a License Reservation mode because my environment is air-gap (no internet connection). My question are: 1. Can I fully use the DNAC in an air-gap environment? 2. In an event of ha...
Hello, which is the MTBF for Ethernet modules NIM ES2-4 or NIM ES2-8 ?Thanks in advance MTBF, NIM ES2-4
Hello everyone,In the near future, we will be deploying a physical 32-core Catalyst Center appliance in a customer network for the first time.After reading both the Third-Generation Appliance Installation Guide and the User Guide (both release 2.3.7 ...
Hello guys. I'm trying to perform a POST Rest API toward Cisco DNAC (Catalyst Center). The body it's like that: [ { "name": "Pool-1", "type": "Generic", "ipv4GlobalPool": "10.0.0.0/8", "ipv4PrefixLength": 2...
Hello, When the double tag frame reaches the destination switch in the 802.1q tunnel, where does it begin to decapsulate the outer tag of the frame as it reaches the end of the tunnel? Does it start at the ingress switchport trunk, or the egress swit...
Dear friends,I hope anyone can help with this issue:I need to capture the packet traffic for one of the interfaces of a 2960 using the EPC utility. The switch has the following hardware / software: WS-C2960CX-8TC-L, 15.2(4)E6, C2960CX-UNIVERSALK9-MSe...
