how to configure trunk for DNAC switch port using DNAC appliance?

[jaheshkhan]

how to configure  trunk for DNAC switch port using DNAC GUI ?

[Preston Chilcote]

You will need to use a day-N configuration template for this.  In later versions you can change the data and voice vlans on an access port, as well as interface description in the Inventory details for a switch, but not any trunk link parameters.

[jaheshkhan]

can you pleae tell me the steps. im not very familiar with this.

[balaji.bandi]

check some templates :

https://blogs.cisco.com/networking/dnactemplatesdayn-pt4

check DNA centre Templates :

https://www.youtube.com/@CiscoDNACenter