Start the configuration wizard over again

[richard.abeyta]

After completing the CIMC setup and rebooting server you then get dropped into the Cisco DNA Center Configuration Wizard. I set the cluster and host subnets incorrectly when using the configuration wizard and now I cannot get back to reconfigure those settings. You cannot do them through the CLI or by factory reset of some sort. 

How am I able to start over from scratch on the Cisco DNA Center Appliance?  Also, how am I able to see which release of Cisco DNA Center is currently being used?

[Tomas de Leon]

You will need to rebuild the Cisco DNAC from scratch.  In order to accomplish you will need to open a Cisco TAC Case so the TCE can publish the Cisco DNAC ISO file for rebuilding the Cisco DNAC.  Please take a Screenshot of your CIMC screen that shows your Cisco DNAC's Serial# and Hardware PID.  This will help when opening a Cisco TAC Case.

Cisco Digital Network Architecture Center M4 Appliance Installation Guide, Release 1.3
https://www.cisco.com/c/en/us/td/docs/cloud-systems-management/network-automation-and-management/dna-center/1-3/install_guide/M4/b_cisco_dna_center_install_guide_1_3_M4.html

Cisco Digital Network Architecture Center M5 Appliance Installation Guide, Release 1.3
https://www.cisco.com/c/en/us/td/docs/cloud-systems-management/network-automation-and-management/dna-center/1-3/install_guide/M5/b_cisco_dna_center_install_guide_1_3_M5.html

[Mike.Cifelli]

You should be able to use your DNAC dongle that came with the physical appliance with a crash cart to get CLI access. Once you have kvm access run $sudo maglev-config update
Once you run that you should get the maglev wizard to fix your interfaces. HTH!

[richard.abeyta]

Hello,

Unfortunately, the kvm console only allows you to reconfigure the interfaces. You are not able to reset all the options that you were originally able to configure during the setup wizard. I do believe the only solution to this problem is getting a custom ISO image and starting from scratch for this particular issue.

[Farhan Mohamed]

Ideally if you break the configuration in anyway, where you would need to re-built and start from all over again, then connecting with TAC is ideal thing to do as TAC will get you the iso image from where you can launch back once again. Please take a Screenshot of your CIMC screen that shows your Cisco DNAC's Serial# and Hardware PID.  This will help when opening a Cisco TAC Case.

Cisco Digital Network Architecture Center M4 Appliance Installation Guide, Release 1.3
https://www.cisco.com/c/en/us/td/docs/cloud-systems-management/network-automation-and-management/dna-center/1-3/install_guide/M4/b_cisco_dna_center_install_guide_1_3_M4.html

Cisco Digital Network Architecture Center M5 Appliance Installation Guide, Release 1.3
https://www.cisco.com/c/en/us/td/docs/cloud-systems-management/network-automation-and-management/dna-center/1-3/install_guide/M5/b_cisco_dna_center_install_guide_1_3_M5.html

Try to get CLI access and launch KVM and run : $sudo maglev-config update, once you do it will get lot clearer on what got broken and how to fix it.