"Get-UcsNetworkLanNeighborEntry" doesn't work for breakout ports

[zwphoenix]

I have 6332 FIs and network uplink is 40 Gbps ports that configured as breakout ports and connected 1 of the 4 ports to 10 Gbps upstream port on Cisco 7K switches.

I'm able to show cdp neighbor by SSH. But cannot get any output by PowerTool command Get-UcsNetworkLanNeighborEntry.

Same command works fine on 6200 FIs 10 Gbps uplinks. Does anybody see same issue like my case? Is it a bug?

[mojafri]

Could you please verify if "Info Policy" is enabled? 

Enabling the Information Policy via UCSM GUI.

• Go to “Equipment” -> “Policies” tab -> “Global Policies” tab -> “Info Policy” area.
• Change to “Enabled“

Please vote if this helps.

Regards,

MJ