cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1023
Views
0
Helpful
3
Replies

Cat9000v - Change Serial Number

dodgerfan78
Level 1
Level 1

How can we change the serial number on a Cat9000v so we can import multiple into Catalyst Center? Is this possible yet in 2.7?

3 Replies 3

dodgerfan78
Level 1
Level 1

Please help. 

Hello @dodgerfan78 ,

it seems that you are not the only one facing this issue - I also stumbled upon it and after a bit of research I found this link:

https://community.cisco.com/t5/cisco-modeling-labs-discussions/virtual-cat-9k-with-cml-dnac/td-p/4920879/page/2

The workaround stated in the community thread is to change the <prod_serial_number> property to be the desired serial number in the CONFIG/vswitch.xml before powering up the vm.

HTH

Regards, LG
*** Please Rate All Helpful Responses ***

Torbjørn
VIP
VIP

The serial is randomised upon first boot in the image version shipped with 2.8. I would suggest upgrading CML or importing the new refplat instead of trying to make it work on 2.7 - I spent quite a lot of time trying to make it work on 2.7 with very little success.

Happy to help! Please mark as helpful/solution if applicable.
Get in touch: https://torbjorn.dev