Hello
After CML upgrade from 2.5.0 to 2.5.1 I cannot start nodes. I see "Failed to validate and define (Disk clone failed. Source image may be invalid or missing.)"
I have all image definitions copied from refplat iso to disk. This was not toche...
Hi,Last week, I was able to reserve a CML lab as usual, but in the last few days, the reservation procedures took too long. Then, a window will pop up and say, Resolve conflict, and show only one faraway time slot (as shown in the image that I have ...
I have CML2 running on a VM in VMWare Fusion. I was able to login into the web ui after initially setting up the account, but now I can't authenticate the account in the web ui. I can authenticate in the CLI of the VM, but not in the web ui for some ...
So I'm running a VM in a low end platform, I will purchase a dedicated machine to run CML as smooth as possible . I already registered the license that comes with personal in my account. Will i have problems activate the same license in my new deploy...
Hi all, managed to sort another issue thanks to this sub so thought I’d ask another question about an issue with a VLAN. Lab setup with an ASA 5510 and SG200-50P (I know no CLI but it was all I could get my hands on). Anyway I have set up 2 VLANs on ...
Hello,I've a problem with custom image IOS XRv 6.6.3 in CML. I've loaded it (qcow image) and attached as second under current node definition IOS XRv. In resule when I'm adding a new node I