Cisco Software Discussions

I received a Cisco c8200-ucpe-1n8 routerI put it under the power supply but I can't access the router due to the wrong login and passwordI tried all the default Cisco login and password settings but to no availThe router doesn't have a reset buttonI ...

Hello,We recently installed SSM On-prem v9-202412. As our security standard, port 80 must be disabled, but I have not found any way to do it.I tried to use Linux firewall to block port 80 (sudo firewall-cmd --zone=public --add-rich-rule='rule family=...

I just recently bought my asa from ebay when I boot it up it goes into rommon and when I went to the cisco website to find it I cant find anywhere

Im trying to find 12.2TX ios for a 2612 router, I have looked everywhere and contacted TAC over the phone but I have not been successful. I was hoping someone could help me out I understand that the 2612 is very old and no longer supported but idk wh...

I am using a standard IP named ACL and have a question regarding sequenced entry additions. It seems that when I add a new IP and include the sequence number, then issue sh ip access-lists, it appears in some random location but with the sequence num...

Hello!So I can't find that on software.cisco.com - seems like only a few of hashes are available there? Or am I just unable to use that website?I have these old IOS images that I bought long time ago, but I'd like to verify its SHA256/MD5 hashes to m...

Hello all,macOS Sonoma & Sequoia (others not tested). Users in home office get an error while connected with CSC 5.1.4.74 via tunnel split to the company : "Da ist beim Teilen etwas schief gelaufen. Versuchen Sie es bitte erneut" - "There is somethin...

Hi Folks, Is there anyway I can remove a single extcommunity rt under a route-map without affecting the other rts?For example, if I have the route-map below: route-map set-mpls-rt permit 10match ip address prefix-list route-list-priset extcommunity r...

I have a Cisco 2960, named ACL and sequenced entries. Similar to this:Standard IP access list Name10 permit x.x.x.x20 permit x.x.x.x30 permit x.x.x.x40 permit x.x.x.x50 deny allYesterday, I issued command: no 20 permit x.x.x.xImmediately after, I los...

Hello,I am attempting to push syslogs to a syslog server using fluentd as the aggregate. I am having an issue with the log adding a colon after the priority facility, i.e. <190>: DATE. Fluentd can accept the priority facility but not the : specified ...

I have 2 C9407R in stackwise virtual. Then there is multiple power outage on both, then the startup-config disappeared each time I apply power back.I was applying the backup config each time to restore the network.But now:1. remote/ssh stopped workin...

I understand there are three firmwares - lightweight for use with external wireless controller, but what about IOS XE and EWC?Basically what I want to do is connect to my ISP router and extend my internet to a deadzone with the cisco access point wit...

Hi All,i am unable to find the system uptime. Tried "show version" on both CLish and fxos mode also dont show the uptime at all.Anyone have any idea where to find the device uptime ?