Cisco Jabber 10.5 where did Rich presence go ?

[common user]

Hi do some of you know if it is possible to enable Rich presence in jabber 10.5 ?

The only state i have is Basic presence.

Basic presence (Available, Away, Offline, Do Not Disturb)

Rich presence (In a meeting, On a call, or a custom presence state)

Thanks

Henrik Jensen

DK

[Amit Kumar]

custom presence is still available;

- lets say if you have to configure a custom available status message; all you need to do is just bring the mouse cursor to the AVAILABLE option and do one lft. mouse click; that will enable the editor and you can enter the custom status message.

- please refer to this link for more information; http://www.cisco.com/c/dam/en/us/td/docs/voice_ip_comm/jabber/Windows/10_5/qsg/JABW_QuickStartGuide_10-5.pdf

- on a call status is dependent upon sip subscribe received via the call manager; when you are going to be on a call and jabber is controlling that phone device (softphone or deskphone) it will automatically change the status to on a call.

- in a meeting status will depend on whether you have configured calendering integration is done with the outlook or not?

- please rate if this helps.

[common user]

Hi Amit,

I know it is possible to make the custom status messages. 

The jabber version 10.5 does not change to "on a call", but version 9.7 does. 

And another thing i have discovered  is off line user do not show line state in 10.5 but in 9.7. 

Do you know if i need at higher version of CUPS than System version: 9.1.1.31900-1 to support 10.5 ?

[Amit Kumar]

For on-premise setup we support the following with j4w 10.5;

http://www.cisco.com/c/en/us/td/docs/voice_ip_comm/jabber/10_5/CJAB_BK_D6497E98_00_deployment-installation-guide-ciscojabber/CJAB_BK_D6497E98_00_deployment-installation-guide-ciscojabber_chapter_011.html#CJAB_RF_OD4EE83D_00

On-Premises Servers for Cisco Jabber for Windows and Cisco Jabber for Mac

 

Cisco Jabber supports the following on-premises servers:

•  Cisco Unified Communications Manager version 8.6(2) or later
•  Cisco Unified Presence version 8.6(2) or later
•  Cisco Unity Connection version 8.6(2) or later
•  Cisco WebEx Meetings Server version 1.5 or later (Windows only)
•  Cisco WebEx Meetings Server version 2.0 or later (Mac only)
•  Cisco Expressway Series for Cisco Unified Communications Manager
  •  Cisco Expressway-E Version 8.1.1
  •  Cisco Expressway-C Version 8.1.1
•  Cisco TelePresence Video Communication Server
  •  Cisco VCS Expressway Version 8.1.1
  •  Cisco VCS Control Version 8.1.1

Please suggest what version of call manager and cups/im and presence are you using ?

[Todd Hebert]

Add a Presence gateway on the IM&P Web admin interface, which would be the CUCM.