I am investigating a private vlan solution to accomplish an end goal of host isolation. In the end I'd like to see my endpoints not able to communicate with each other for additional privacy/security.
While experimenting with this I ran into the "switchport protected" option on a per-port basis. It appears to work fine for most of my use cases, except that when another device on the same switch/vlan attempts to call the other over Cisco Jabber the audio is not heard on either side. I also cannot send screen shares or share my video over Jabber. While the use case may be minimal (two users trying to call each other on the same switch stack, which is likely the same floor of the building), I need to ensure that all current uses transfer over during the final change window.
My question is this: Does Cisco Jabber use the data vlan for all traffic, or is there a way to have it tag its traffic outbound as the voice vlan?
I'm investigating an alternative solution here to have the data vlan be an isolated pvlan and the voice vlan be a community pvlan, allowing inter-floor voice vlan traffic to establish as normal. This of course relies on the idea that Cisco Jabber uses the voice vlan, or there is some way to separate out those traffic flows to permit them.
Jabber does use the data VLAN with the workstation. Presumably, if you could configure the workstation's NIC to support tagging, multiple adapters, and routing accordingly, you could route the traffic onto the voice VLAN.
You can also try to use a trusted relay point/MTP, which can break some things, or MRA, which can break other things, but both of those can solve whichever problem you're tackling here.
The 2020 IT Blog Awards, hosted by Cisco, is now open for submissions through October 16. Submit your blog, vlog or podcast today. For more information, including category details, the process, past winners and FAQs, check out: https:...
We have CUCM and CUC (v12.5) which has been directly registered to Cisco's Smart Licensing, but today's I noticed this error from RTMT "Smart Licensing Authorization Renewal Failure". I tried to force the re-authroization and re-registration and now it sa...
Hello I have a Cisco 7841 3pcc Phone, if I specify a custom ringtone and try to play it, it is spit out in the log> Bad parameter in Ring File field: w = tftp: //192.168.220.120/TEST.rawand the standard sound plays.-----------4047 ERR Jan 17 16: 15: 33...