Cisco Webex connect to Cisco Video Conference

[daniel86]

Hello,

is there any way to connect to Cisco Video Conference solutions (H.323/SIP) with Webex? A lot of partners are using this and we are trying to find a way to take part of it.

Thanks

[Jonathan Schulenberg]

I don’t understand your question. Webex sites on a modern version and with video platform 2.0 enabled - which should be everyone not on old lockdown releases by now - will see SIP/H.323 URI and H.323 direct IP dial-in on the meeting invite.

[Mike_Brezicky]

Webex with CMR / Video 2.0 will provide a SIP URI or H.323 address to call into. Sites should also have a pilot - meet@<sitename>.webex.com to call into. There are some exceptions with certain CCA sites though.
Getting the video devices to reach the meeting depends on your systems. If they are Room Kits registered to Webex, its a direct call. If your VC endpoints are on premise, you need a gateway into webex such as VCS or Expressway.

[Vijay Kumar Yadav]

Yes, its possible. If your endpoints are registered in CUCM then you can deploy Expressway-C/E. Whenever you initiate a WebEx meeting you can enter the SIP address of your endpoint in the meeting and hence you will use the endpoint for Video/Audio.

There are different other ways to achecive it based on your requirement.

Hope it Helps

Please rate helpful posts

VJ