cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
268
Views
0
Helpful
2
Replies

Jabber in phone-only mode connectivity issue via MRA

Emmanuel Akum
Beginner
Beginner

I'm getting a 502 response code when trying to connect with Jabber via MRA and can't figure out why this is happening.

 

From Jabber Logs

I'm get  a 502 response code when [csf.httpclient] [csf::http::performRequest] - *-----* HTTP response code 502 connect code

 

From Expressway E logs

traffic_server[2044]: Event="Sending HTTP error response" Status="502" Reason="connect failed" Dst-ip="x.x.x.x" Dst-port="57395" UTCTime="2022-07-07 22:51:52,999"

 

Jabber is deployed in phone-only mode. There is no IMP Server.

Expressway is deployed in a cluster

There are no issues when connecting internally/ directly to the CUCM 

Expressway C Nodes are in the same subnet as the CUCM Nodes. There is no firewall between them.

There are no issues connecting 88XX phones via MRA

 

2 Replies 2

Adam Pawlowski
VIP Advocate VIP Advocate
VIP Advocate

I've only ever seen this error code in the past when a UCM subscriber is not reachable from the Expressway C, when it was offline or a needed service was not running. I don't believe the 8800 series phones use User Data Service (UDS) when connecting through the Expressway, perhaps that service is not running on a UCM? I am just speculating, but, the solution isn't really aware when a service is shut off, node is down, etc and assumes you have everything available for it to run.

User Data Service (UDS) is running on all the nodes in the CUCM cluster

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: