09-26-2011 08:58 AM - edited 03-14-2019 08:37 AM
I'm curious where CET tool pull the configuration data from? Was it from a database or from a flat file on UCCX?
Thanks!
09-26-2011 10:05 AM
Hi
I imagine it would be from flat files - that's how it was on the Windows versions and the code used to read it then would (I imagine) be pretty portable since it's Java.
Have you tried searching the fs for similar file names to v7 in recovery mode? They were all in folders call wfavvid/ClusterData/default/com.cisco.crs.cluster.config.AppAdminSetupConfig and so on...
Aaron
09-26-2011 10:24 AM
Thank you very much!
I think I found it under \opt\cisco\uccx\ClusterData\default.
Michael
09-26-2011 10:33 PM
Good to know.. might save a TAC call or two :-)
I just found a little note-to-self about changing one of the settings (for FRESH_INSTALL) - not easy to edit without cet hmm?
Aaron
09-27-2011 05:47 AM
Shouldn't be too difficult.
Open the xml file in corresponding directory. e.g. open the xml in "
/opt/cisco/uccx/ClusterData/default/com.cisco.crs.cluster.config.AppAdminSetupConfig", and look at the blobValue. It's encoded in ASCII.
Translate that with the ASCII table:
You'll get:
46 = F
52 = R
45 = E
53 = S
48 = H
5F = _
49 = I
4E = N
53 = S
54 = T
41 = A
4C = L
4C = L
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide