08-16-2016 07:48 AM
I notice (see attached), that PCCE 11 includes configuration for CVP trunk ID in ICM for 100, 200 and 300.
I understand what the Peripheral ID 100 and 200 are for.
Anyone know what, why and when Peripheral ID 300 is used?
I don't see it in any of the CVP Configuration guides.
Solved! Go to Solution.
08-16-2016 08:45 AM
Gerry,
It's used for trunk utilisation reporting. If you go into the add/configure a gateway help page in CVP OAMP you'll see brief mention of it there.
08-16-2016 08:45 AM
Gerry,
It's used for trunk utilisation reporting. If you go into the add/configure a gateway help page in CVP OAMP you'll see brief mention of it there.
08-16-2016 09:33 AM
Paul,
Thank you.
So just to summarise and help others - this is my understanding.
ICM Network Trunk Group Explorer
Peripheral Number 100 - New Calls into CVP -
Peripheral Number 200 - Pre Routed Calls into CVP Call Server - Calls into CVP Callserver with Correlation ID
Peripheral Number 300 - Gateway Trunk Reporting.
Not 100% sure but I believe / assume that the Gateway Trunk reporting counts the VRU legs on the VXML Gateway.
And not Gateway PSTN calls?
Gerry
08-16-2016 10:23 AM
It's intended for ingress gateway trunk utilisation. I'm not 100% sure whether you could also use it for VRU leg utilisation.
Paul
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: