EIM / WIM 4.3.2 Agent Bulk Import UCCE
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-13-2011 04:28 AM - edited 03-14-2019 08:04 AM
When one runs the integration wizard all the agents in UCCE are also imported. The thing is that we can only run the wizard once. So every time I add agents to UCCE and want them to use EIM / WIM I have to manually map them. It there a way to do this in bulk or does this have to be manually done? Its ok to do this manually for few agents but the problem is when there are many agents.
Victor
- Labels:
-
Other Contact Center
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-13-2011 03:06 PM
Hi
I dont believe there is any standard way of doing this other than mapping the agents manually.
When doing an install though it is best to create a Non-Production/Test deparment first. You can run the integration wizard against this department and bring in a couple of test agents. Once happy you can then create more departments and then run the integration wizard again against the new departments. Remember you cannot delete a department once you have created it.
Thanks,
Matt
