05-04-2009 10:29 PM - edited 03-14-2019 04:02 AM
We have the setup of HIPCC 7.0 and CVP 3.1 and CCM 4.1, we observed that agent reserve time is going high atleast 12 seconds. if anyone knows how to reduce this reserve time, work around to fine tune it. please advise ASAP.
05-04-2009 11:23 PM
Hello,
I suppose you are talking about reserved time in reports.
When an agent is offered a call, that agent is being reserved. So, ringtime (which defaults to 12 seconds) equals reserved time, as the agent is not available for other tasks.
You probably do not want to change the ringtime too much.
HTH, please rate helpful posts.
--bas
05-04-2009 11:37 PM
How about using auto answer on their phones? That will probably bring it down to a half to a full ring. If your agents do not have auto answer it might be in their best interest to let the phone ring as long as possible without invoking RONA.
david
05-05-2009 01:20 AM
Hi All,
do you mean that webview reports include the ringtime in reserve time?
because sometimes we are getting 12 secons and most of the time 4 secons 8 seconds. like this kindly clarify it. or advise me which document i can refer....
05-05-2009 01:27 AM
Prakashj,
Yes, ringtime is included in reserved time.
You have two options;
1) Interpret the reports with the knowledge that ringtime is included in reserved time (which is normal).
2) Define autoanswer for your agents to reduce ringtime/reserved time as David suggested.
--bas
05-05-2009 01:40 AM
Dear Bas,
Thanks for the information, if possible provide me document where cisco refer this point, since i have to give explanation to customer.
with Regards,
Manivannan
05-05-2009 01:47 AM
Manivannan,
Check this document, page 57, check the "Reserved" explanation.
HTH, please rate helpful posts.
--bas
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide